SUNNY SG303-04 X-tra Series Self-Contained Emergency Light User Manual

SUNNY SG303-04 X-tra Series Self-Contained Emergency Light

User Manual

The Self-Contained Emergency Light X-tra Series comes in two models: SG303-04, and TM606-03. It has status indicators and testing buttons, as well as a remote control. The features include:

1. LEDs with a lifetime of over 50,000 hours, provide bright and constant illumination throughout its operation.
2. Provides bright and constant illumination throughout its operation.
3. The unit has an AUTO TEST function that will self-test every 30 days for a duration of 30 minutes.
4. The emergency lamp has a special function and can be used instead of desk or floor lamps.

Installation and Operation

To install and operate the unit, follow these steps:

1. Check to make sure that the power socket of the home or building is providing a 220 Vac current.
2. Install the unit properly at the location where emergency light is needed. Check to make sure the unit is properly secured to prevent possible accidents.
3. Plug the unit into a socket that provides 220VAC 50Hz power supply.
4. Press the ON switch and hold down for about 3 seconds until the LED ON turns on.
5. After the unit is provided with a 220Vac power supply the following indicators will show:
6. LED AC will turn on showing that the unit is receiving a 220Vac power supply.
7. LED ON will turn on to show that the unit is operational.
8. To test the unit, unplug the unit from the power socket, the unit’s lamp should turn on. After plugging the unit back into the power socket, the emergency light should turn off automatically after about 5-8 seconds.
9. The unit can be turned on using the infrared remote and set to stay on for the desired amount of time, after which the unit will automatically turn off and resume its function as an emergency light.
10. During power outages, the emergency light should automatically turn on and will turn off automatically and start charging the battery once power is restored.
11. The unit will automatically perform self-tests every 30 days counting from the time the ON switch was pressed. The test will take 30 minutes after which to unit will return to its normal operation.

Important Note on Using the Unit

When using the Self-Contained Emergency Light X-tra Series, keep in mind:

1. The unit should be installed indoors away from direct sunlight and rain or moisture.
2. The unit should be stored in temperatures under 25 Degree Celsius and the battery should be charged every 1 month to maintain its operational life.
3. Always press the ON switch every time after installation to turn on the unit.

Initial Trouble Shooting

If you encounter any problems while using the unit, consult this table for possible solutions:

Power not getting to the unit after plugging in. The LED AC
light does not turn on.| The power socket might not have any power. The plug or socket
is loose. The AC.220V fuse is blown.| Check the 220VAC power supply. Check the plug and socket.
Contact customer service.
The emergency light does not turn on after the power went out.| The unit is not plugged in. The lamp is faulty. The circuit’s
wiring is loose. The DC fuse is blown.| Check that the unit is plugged in. Contact customer service.
Contact customer service. Contact customer service.

Self-Contained Emergency Light X-tra Series

Model: SG303-04, TM606-03

Status Indicators and Testing Buttons Remote Control

Features

1. LEDs with a lifetime of over 50,000 hours, providing bright and constant limitations throughout its operation.
2. Provides bright and constant illimitation throughout its operation.
3. The unit has an “AUTO TEST” function that will self-test every 30 days for a duration of 30 minutes.
4. The emergency lamp has a special function and can be used instead of desk or floor lamps to provide illumination even when there are no power outages. The unit can provide bright and long lasting illumination and can be set to turn off automatically after 1,2,3,6 or 12 hours through the infrared remote.
5. The unit has a Battery Low Voltage Cut-Off to prevent the battery from draining completely, which helps to extend the life of the battery.
6. The unit charges the battery with a constant Voltage while limiting the current, extending the life of the battery.
7. The unit has a Time Delay function to keep the emergency lights on for another 5-8 seconds after normal power has been restored to make sure the regular lights are back on before turning off.

Installation and Operation

1. Check to make sure that the power socket of the home or building is providing a 220 Vac current.
2. Install the unit properly at the location where an emergency light is needed. Check to make sure the unit is properly secured to prevent possible accidents.
3. Plug the unit into a socket that provides a 220VAC 50Hz power supply.
4. Press the “ON” switch and hold down for about 3 seconds until the “LED ON” turns on.
5. After the unit is provided with a 220Vac power supply the following indicators will show.
6. LED AC will turn on showing that the unit is receiving a 220Vac power supply.
7. LED ON will turn on to show that the unit is operational.
8. Testing the unit.
9. Unplug the unit from the power socket, the unit’s lamp should turn on. After plugging the unit back into the power socket, the emergency light should turn off automatically after about 5-8 seconds.
10. The unit can be turned on using the infrared remote and set to stay on for the desired amount of time, after which the unit will automatically turn off and resume its function as an emergency light.
11. During power outages, the emergency light should automatically turn on and will turn off automatically and start charging the battery once power is restored.
12. The unit will automatically perform self-tests every 30 days counting from the time the “ON” switch was pressed. The test will take 30 minutes after which to unit will return to its normal operation.
13. If a power outage occurs during the test the emergency lamp will be activated and the test will be canceled.

Important Note on Using the Unit

1. The unit should be installed indoors away from direct sunlight and rain or moisture.
2. The unit should be stored in temperatures under 25 Degrees Celsius and the battery should be charged every 1 month to maintain its operational life.
3. Always press the “ON” switch every time after installation to turn on the unit.

Initial Trouble Shooting

Dimension (mm)

FRONT VIEW

BACK VIEW

SIDE VIEW

Remote Control

• (1) Turn on the lamp for 1 hour
• (2) Turn on the lamp for 2 hours
• (3) Turn on the lamp for 3 hours
• (6) Turn on the lamp for 4 hours
• (12) Turn on the lamp for 5 hours
• (off) Turn off the lamp

Terms for Warranty and Service

1. The product will only be under warranty if the customer is in the “warranty card” and return the “return part” to the company within 7 days of purchasing the product.
   If this is not done within the specified time then the warranty will be considered void.

2. The warranty only covers the unit’s internal parts for the duration specified by the company counting from the date of purchase.

3. Please show the warranty card every time when contacting our service department or the dealer you purchased the unit from.

4. The warranty will be considered void in the following cases.

   • The unit has been used outside of its intended use specialed in the manual.
   • The unit has been used with equipment that does not meet the specifications specific to the manual.
   • The unit has been damaged from impact, for example, parts are dented, scratched missing or distorted.
   • The unit has been modified or repaired by people not officially certified by our company.
   • The Sticker Warranty Void has been removed or torn.
   • The unit is damaged from negligence or incompetent use, for example, the battery is swollen, the battery has been overcharged, the battery has been damaged from quick charging, the battery has been short-circuited, the battery’s charge has been completely drained.
   • The unit has been stored improperly, for example, it was exposed to moisture causing rust and damage to the internal circuitry.
   • Damage was caused by a malfunction in the AC power supply.
   • Damage from a natural disaster such as offer, moisture, submersion in liquids, chemical damage or from unavoidable circumstances.
   • Damage from animals or insects.

Note : Please read the manual carefully before installation and operation to understand how to properly operate the unit.

For any further questions about your product
please feel free to contact SUNNY’s customer service department.
Tel. (+66) 02-948-4450-2
E-mail: service@sunnyemergencylight.com

IsOn Import-Export Co., Ltd.
2915-2917 Ladprao Road, Klongjan, Bangkapi, Bangkok 10240

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>