Litter-Robot LR4 OdorTrap Packs Installation Guide
- June 9, 2024
- Litter-Robot
Table of Contents
Litter-Robot LR4 OdorTrap Packs
Installing OdorTrap TM Packs
Litter-Robot 4 can be equipped with (2) OdorTrap™ Packs that are installed on
the outer bottom area of the globe. The packs sit directly over the waste
drawer to eliminate odors.
(OdorTrapTM Packs are sold separately and not required for the unit to
function.)
How to install
☑ Press and hold the Cycle and Empty buttons on the control panel for 3 seconds, or tap “Replace Filter” under Controls in the app.
☑ A clean cycle will begin; the cycle will pause when the globe reaches the “replace filter” position.
☑ Open the bonnet: Press and hold the latches on both sides of the bonnet, then lift and rotate the bonnet to its open position to reveal the filter pocket.
☑ pen the filter cover and remove the carbon filter (if installed). Place 2
Odor Trap™ Packs under the filter cover and reinstall the cover. Under normal
use, 2 packs should last approximately 1 month.
(Note: OdorTrap™ Packs may shift as the globe rotates.)
☑ Close the bonnet: Rotate the bonnet downward over the globe and push down on the bonnet from the top to make sure it is latched and secure.
Press the Cycle or Reset button to resume the clean cycle; when the clean cycle has ended, press the Reset button to zero the weight sensors.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>