Kwikset 258 Series Halifax Deadbolt Installation Guide

53973 / 01
Installation Guide
1-800-327-5625
www.kwikset.com

This manual can be used to install a variety of deadbolts.

*Tools

*Tools will depend on install type
For Low Profile Deadbolts Models
(258 series, Uptown, Downtown, Midtown, and San Clemente rectangular)
Follow steps 1 through 6

For Regular Deadbolts Models
(158, 159, 660, 665, 780, 816, 980, 985, Halifax and Milan)
Follow steps 7 through 11

Scroll to the bottom if you need help in preparing your door

Extend latch bolt (Low profile models)

Adjust the backset of the latch (if needed)

A Hold the latch in front of the door hole, with the latch case flush against the door edge.

B If the D-shaped hole is centered in the door hole, no adjustment is required. Proceed to step 4. If the D-shaped hole is NOT centered, adjust latch. See “Latch Adjustment” (step 3C).

C Latch Adjustment (only if needed)

Install Latch

Determine required mounting screws

Measure the thickness of your door to determine the required mounting screws for step 6.

Install deadbolt interior (Low profile models)

Install deadbolt exterior

To finalize your installation, proceed to Step 12.

Extend latch bolt (Regular deadbolt models)

Adjust the backset of the latch (if needed)

A Hold the latch in front of the door hole, with the latch face flush against the door edge.

B If the latch holes are centered in the door hole, no adjustment is required. Proceed to step 9.
If the D-shaped hole is NOT centered, adjust latch. See “Latch Adjustment” (step 8C).

C Latch Adjustment (only if needed)

Prepare latch (if not pre-assembled)

Install latch (Regular deadbolt models)

Install deadbolt (Regular deadbolt models)

A Remove cover plate from interior cylinder (For double cylinders only).

Install strike on door frame

Preparing Your Door

For consumers requiring the door prep template, please visit:
Drilling instructions

Use template to mark holes on door

A Select the template that allows you to place the template on the EXTERIOR side of door. Fold template along fold line and place fold line along the edge of door. Place centerline approximately 38 in (97 cm) from the floor.
B Mark hole on the face of the door. Select desired backset before marking hole. If there is another hole in the door, or if you are drilling double doors, make sure to keep the backset consistent.

C Mark hole on the edge of the door. Select door thickness before marking hole.

Drill holes in door

C Drill from one side until the point of drill just breaks through, then complete hole from the other side to prevent splintering.

Determine which latch will be installed and prepare door edge

Prepare door frame for strike

Register your product at www.kwikset.com/productregistration
Rate your product at www.kwikset.com/reviews

WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be defeated by forcible or technical means, or evaded by entry elsewhere on the property. No lock can substitute for caution, awareness of your environment, and common sense. Builder’s hardware is available in multiple performance grades to suit the application. In order to enhance security and reduce risk, you should consult a qualified locksmith or other security professional.

©2023 Spectrum Brands, Inc.

References

• Door Locks, Door Hardware, Smart Locks & Smartkey Technology | Kwikset
• Register Your Product | Kwikset
• Write a Review of your Kwikset Lock Product for a Chance to Win $250 a Month | Kwikset

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>