FULHAM CTBRCB02JM02 Bluetooth SmartBridge 600W Lighting Controller Instruction Manual

CTBRCB02JM02 Bluetooth SmartBridge 600W Lighting Controller

Product Information

• Product Name: CTBRCB02JM02
• Installation Instructions: 15
• Certification: E498565
• IP Rating: IP66
• RoHS Compliant
• Electrical Specifications:
  • Input Voltage / Frequency: 120 – 277VAC (+/-10%) 50-60Hz
  • Input Current: 5A Max.
  • Input Power: 600W (Max.)
  • Standby Power: Not specified
  • Maximum Load: Not specified
  • RFI / EMI: Not specified
  • RF Communication Type: Not specified
  • Input Surge Protection: Yes
  • Transmission Range: Not specified
  • Dimming Control Type: Not specified
  • Potting / Degree of Fill: Not specified

Product Usage Instructions

• This device is designed for use in fixtures listed for dry, damp and wet locations.
• Before installation or servicing, ensure that the AC power is turned off.
• All electrical connections should conform to the National Electrical Code and all applicable local regulations.
• Avoid letting power supply cords touch hot surfaces or mounting the device near gas or electric heaters.
• The equipment should be mounted in locations and heights where it will not readily be subject to tampering by unauthorized personnel.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical equipment and this lighting device basic safety precautions should be followed at all times including but not limited to the following :

PLEASE READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY

• This device is designed for use in fixtures listed for dry, damp and wet locations.
• CAUTION: Make sure all electrical connections conform to the National Electrical Code and all applicable local regulations
• CAUTION: Do not let power supply cords touch hot surfaces.
• CAUTION: Do not mount near gas or electric heaters.
• CAUTION: Equipment should be mounted in locations and heights where it will not readily be subject to tampering by unauthorized personnel.

ASSEMBLY AND FIELD INSTALLATION WIRING:

• WARNING: AC power must be off before proceeding with assembly, installation or servicing of driver.

ELECTRICAL SPECIFICATIONS

Fulham’s EliteBlue commissioning app can be found on the Apple app store by searching “EliteBlue”. For web app, please visit https://eliteblue.fulham.com
Complete commissioning manual can be found at: https://www.fulham.com/PDFs /eliteBlue-commissioning-manual.pdf

MECHANICAL DATA

Mount screw: #10-24*1 inch
Mounting hole for threaded pipe: 7/8” (22mm)

Overall Dimensions

Length| 5.17”

[131.5mm]
Width| 2.26 ” [57.6 mm]
Height| 1.29 ” [33mm]
Wire Length
AC Input (White/Black)| 12.4” [315mm]
LED Output

(Red/Black)

| 12.4” [315mm]
Control 0-10V

(Pink/Purple)

| 12.4” [315 mm]
RJ12| 17.3” [440 mm]
Ground (Green/Yelow)| 12.4” [315 mm]

Notes:

1. Driver has two (2) mounting tabs with a round hole in each.
2. Fasten a screw through the mounting tab if mounted on a flat surface.

Notes: Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.

FCC Caution. This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Restoring Factory Settings

• To reset the unit you will need to place and hold a magnet for 10 seconds on the reset icon on the location of  the unit shown in the image below.
• Once the magnet has been placed the Indicator Light will stay lit and begin to flash until it shuts off indicating that the unit has been successfully reset.
• Remove the magnet from the unit, the Indicator Light will light up and flash repeatedly
• The unit is now ready to be provisioned.

Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250
Tel.: 1-323-779-2980
Fax.: 1-323-754-9060.
Specifications subject to change without notice.

Email:order@fulham.com www.fulham.com

References

• Fulham: Lighting Solutions | LED Drivers | Ballasts | Emergency | Modules
• Fulham EliteBlue Commissioning

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>