VOGUE 243235 Romeo Floor Mounted Bath Filler Instruction Manual
- June 4, 2024
- VOGUE
Table of Contents
VOGUE 243235 Romeo Floor Mounted Bath Filler
Bath Mixer
Installation Instruction
All information is compiled according to the latest published product information. The company reserves the right to change product characteristics, packaging or product types at any time without notice. The manual includes important installation, maintenance and cleaning content, please give this information to the user to read.
Note
- Be sure to flush the water supply pipe thoroughly to remove impurities in the pipe. Ensure to clean the water supply pipe before installing to avoid being jammed.
- The cold-water supply must be connected on the right and the hot-water supply on the left.
- Check the installing dimension according to the Figure and ensure it is installed correctly.
- Comply with local pipeline installation regulations.
- The minimum operating pressure of the switch is0.05Mpa(0.5Bar).
- Hot-water inlet must not be over 80°C.
- Maximum operating pressure of shower: 0.5 MPA (5 BAR). Pressure Relief Valves shall be installed when water pressure exceeds 0.5 MPA (5 bar). Maximum operating temperature and ambient temperature of the shower:60°C
Instructions for use
Turn the handle gently, clockwise to cold water, counterclockwise to hot water. Switch the initial position of the outlet water; gently lift the switch button, and shower water.
Mounting dimensions
Installation steps
Installation result check
Make sure all connections are tightened. Make sure the handle is in the closed position. Use tools to remove the bubble shell, frother, and gasket. Remove the hand-held shower, open the main water supply and check for leaks. Open the hot and cold water valves so that water flows through the outlet to remove debris. Switch to hand-held shower, remove debris, clean screen gasket shutoff valve. Re-install foam starter and hand-held shower heads.
Hand-held shower maintenance
The impurity or scaling in the spray hole will cause the water flow deformation and decrease the flow rate. Open the water source, press or Rub the rubber spray hole to remove impurities or scale
Washing
Applicable to all processed surfaces: clean the plating surface with neutral soapy water, and then thoroughly dry the entire surface with a clean soft cloth. Many cleaning agents, such as ammonia, detergent and toilet cleaner, can cause damage to the plating surface. Do not use it for injury.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>