PITAKA MagEZ Slider 2 Compact Multi Device Wireless Charger User Guide
- June 10, 2024
- PITAKA
Table of Contents
- PITAKA MagEZ Slider 2 Compact Multi-Device Wireless Charger
- Product Information
- Product Usage Instructions
- Preparing Your Phone
- Setting Up MagEZ Slider 2
- MagEZ Slider Dock
- Power Dongle for Apple Watch
- MagEZ Battery Pack
- FCC WARNING
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
PITAKA MagEZ Slider 2 Compact Multi-Device Wireless Charger
Product Information
The product complies with FCC radiation exposure limits for an uncontrolled environment. The FCC ID for the device is 2ARI5-MSPD1-02 and has been evaluated to meet general RF exposure requirements. During device operation, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected to ensure compliance with radiation exposure guidelines.
Product Usage Instructions
- Place the device on a flat surface.
- Keep at least a 15 cm distance around the device during operation.
- Ensure there is a 20 cm distance above the top surface of the device.
- Turn the device on by following the instructions in the user manual.
- Follow all other instructions in the user manual for safe and proper use of the device.
Preparing Your Phone
- Install your MagEZ Case 2/3 for iPhone 13/14, Galaxy 522/S23.
- Or use your iPhone 13/14 with or without a Magsafe case
Setting Up MagEZ Slider 2
- Clean and dry your work surface. Peel off the base’s protective film before placement.
- Plug in the MagEZ Slider 2 using a 20W power adapter and cable.
- When the switch is turned up, spin the dock to adjust angle. Or turn it down to fix the dock.
MagEZ Slider Dock
Charging Your Phone
- Slide the Battery Pack into the dock.
- Attach your phone to charge.
- Remove your phone to leave the power bank in the dock.
Charging Your AlrPods or DIiier Ql Earbuds
- Adjust the magnetic stand depending on the size of your AirPods wireless charging case.
- Put your AirPods on the stand to charge it horizontally or vertically.
Power Dongle for Apple Watch
Charging Your Apple Watch
- Remove the lid .
- Magnetically attach the lid to the end of the dongle.
- lnsert the dongle into the MagEZSlider 2 USB-C port
- Plug the Dongle into any powered USB-C port to charge your Apple Watch. For example:
MagEZ Battery Pack
Charging Your Phone
- Attach the Battery Pack to the back of your phone and charge at 7.SW.
FCC WARNING
This device complies with part 75 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions. may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device, a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
FCC ID: 2ARI5-MSPD1-02
The device has been evaluated to meet general RF exposure requirements.
FCC ID: 2ARI5-MBP1-02
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>