PITAKA MagEZ Slider Dock 2 and Accessories User Manual

June 10, 2024
PITAKA

PITAKA logo MagEZ Slider Dock 2 and Accessories
User Manual

Preparing Your Phone

  1. Install your MagEZ Case 2/3 for iPhone 13/14, Galaxy S22/S23.

  2. Or use your iPhone 13/14 with or without a MagSafe Case.

Setting Up MagEZ Slider 2

  1. Clean and dry your work surface. Peel off the base’s protective film before placement.

  2. Plug in the MagEZ Slider 2 using a 20W power adapter and cable.
    PITAKA MagEZ Slider Dock 2 and Accessories - plug

  3. When the switch is turned up, spin the dock to adjust angle. Or turn it down to fix the dock.

MagEZ Slider Dock

Charging Your Phone

  1. Slide the Battery Pack into the dock.

  2. Attach your phone to charge.

  3. Remove your phone to leave the power bank in the dock.

Charging Your AirPods or Other Qi Earbuds

  1. Adjust the magnetic stand depending on the size of your AirPods wireless charging case.

  2. Put your AirPods on the stand to charge it horizontally or vertically.
    PITAKA MagEZ Slider Dock 2 and Accessories - verticaly

MagEZ Battery Pack

Charging Your Phone

  1. Attach the Battery Pack to the back of your phone and charge at 7.5W.

*Scan QR code for video instruction.

https://www.youtube.com/playlist?list=PLqCX4DFCLQrGf5qJ4kZbRFnlOLoteq_dN

Scan QR Code Below for Full User Manual

https://www.ipitaka.com/pages/manuals

FCC WARNING
This device complies with part 15 of the FCC Pules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Pules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected. FCC ID: 2ARI5-MSPD1-02
The device has been evaluated to meet general RF exposure requirement. FCC ID: 2ARI5-MBP1-02

Kawasaki K EHD 900 Rotary Hammer - Icon

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals