Goldair GFE255 1850W Flame Effect Heater Instruction Manual

Goldair GFE255 1850W Flame Effect Heater Instruction Manual

General Care and Safety Guide

YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they are supervised or have been given instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

WARNING: You must not cover this appliance. Covering this appliance presents fire risk and will activate the safety fuse; permanently disabling the unit.
WARNING: Do not use this appliance in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constantsupervision is provided.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any flammable material a minimum distance of 1 metre from the air outlet.

• Use only the voltage specified on the rating label of the appliance.

• Keep all objects at least 1 metre from the front, sides and rear of the appliance.

• This appliance is intended for household use only and not for commercial or industrial use.

• Indoor use only.

• Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock or injury.

• Do not use the appliance if it has been dropped or damaged.

• The common cause of overheating is deposits of dust or fluff in the appliance.
  Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.

• • Never use the appliance to dry clothes.
  • Always unplug appliance when not in use.
  • When the appliance has been unpacked, check it for transport damage and
  ensure all parts have been delivered. If parts are missing or the appliance has
  been damaged, contact the Customer Services Team.
  • Do not use if there are visible signs of damage to the appliance.
  • Do not connect the appliance to mains supply until completely assembled and
  adjusted.
  • Ensure hands are dry before handling the plug or main unit.
  • Ensure appliance is on a flat, stable, heat-resistant surface.
  • Do not operate with cord set coiled up as a heat build up is likely, which could
  be sufficient to become a hazard.
  • Carry out regular checks of the supply cord to ensure no damage is evident
  • Do not operate this appliance with a damaged cord, plug or after the appliance
  malfunctions or has been dropped or damaged in any manner. Take to a
  qualified electrical person for examination, electrical service or repair.
  • Do not twist, kink or wrap the cord around the appliance, as this may cause the
  insulation to weaken and split. Always ensure that all cord has been removed
  from any cord storage area and is unrolled before use.
  • It is recommended that this appliance is plugged directly into the wall socket.
  Power boards are not rated to supply power to high wattage appliances.
  • A correctly specified, undamaged extension cord may be used with this
  appliance provided it is used in a safe manner.
  • Do not remove plug from power socket until the appliance has been switched
  off.
  • Do not remove plug from power socket by pulling cord; always grip plug.
  • Do not place cord under carpet or cover with rugs or furniture. Arrange the cord
  so it cannot be tripped over.
  • Don’t place appliance on bedding or on thick & long carpet where the openings
  may get blocked.
  • Switch off and use handle provided when moving
  • Do not place appliance close to radiant heat source.
  • Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to them appliance.

• Do not sit on the appliance.

• Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in hot soapy water only. Always remove plug from the mains supply before cleaning.

• Do not operate in areas where petrol, paint or other flammable liquids are used or stored.

• Do not use this appliance in the immediate surrounds of a bath, a shower, or a swimming pool or other liquids.

• The appliance must not be immersed in any liquids.

• There are no user serviceable parts installed in the unit.

• Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards.

• This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate articles of science, etc. are stored.

• If your appliance does not work, or is not working properly, contact the place of purchase or the Customer Services Team.

Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions.

WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
WARNING: Do not use this heater with a programmer, separate timer, remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.

WARNING:Never leave this heater unattended when in use.

Ensure heater is on a flat, stable, heat-resistantsurface.

Once the heater is in a safe operating position and all switches are in the off position, insert the power plug into the mains outlet and switch on.

CAUTION: Ensure the power cord is not tight because if pulled it may partially pull the plug from the socket. A partially inserted plug will overheat the plug and socket and could result in fire.

Note: When the appliance is turned on for the first time, it may release a slight odour or smoke. This odour or smoke is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.

WARNING: This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

Operating Your Heater

HEAT CONTROL PANEL
The control panel cover is located at the back of the heater; select the desired function.

• Power on/off and flame effect without heating (1) – note: this switch must be in the ON position for heating operation
• Low heat 900W (2)
• High heat 1800W (2+3)

Please note: The flame effect switch (1) must be in the ON position for heating operation.
Heating will not operate if the flame effect switch (1) is not selected.

Bulb Replacement

GLOBE REPLACEMENT
Before replacing globes switch the heater off and disconnect for the power supply.

The light globe fitted to this heater is a 25W G9 halogen globe. Globes are considered a consumable item and therefore are not covered by warranty.

If it is necessary to replace this globe, loosen the screws on the back cover and then remove the cover.

Remove the defective lamp by pulling it out of the holder. Replace with a 25W G9 halogen globe. Take care not to touch the globe with bare hands and ensure that the lamp is pushed home.

Reassemble as per the above instructions in reverse order.

SAFETY DEVICES

This appliance has two protection devices:

• Tilt Switch – this will automatically turn the appliance off if the appliance is not in the correct operating position.
• Resettable Thermal Link – this will automatically disconnect the power to the appliance at a pre-set overheat temperature. To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes. Reconnect the supply to the mains and switch on the appliance. If this occurs, investigate what is causing  theappliance to overheat.

CAUTION: The appliance generates heat during use. Precautions must be taken to prevent the risk of burns, scalds, fires or other damage to persons.

CARE AND CLEANING

• The heater requires regular cleaning to ensure trouble free operation:

• Unplug the heater from the mains supply before cleaning.

• Ensure that the heater has been allowed to cool down completely before cleaning.

• The common cause of overheating is deposits of dust or fluff in the appliance.
  Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.

• Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.

• Never use solutions such as petrol, thinners or polishing agents.

• Ensure the heater is dry before plugging back into the mains supply.

• Do not attempt to dismantle the appliance.

• There are no user serviceable parts. For service or repair, contact an authorised electrical service technician

PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.

SUPPORT AND TECHNICAL ADVICE

Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz

Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@cdbgoldair.com.au

Two Year Warranty

Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months.

Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.

This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out by anyone other than a qualified electrical service technician.

PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.

The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in relation to the goods or services to which this warranty relates.

In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).

Goldair – New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland

Phone +64 (0)9 917 4000
Phone 0800 232 633
www.goldair.co.nz

Goldair – Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone +61 (0)3 9365 5100
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au

Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)

Name___

Address_____

Place Of Purchase____Date Of Purchase__

Name Of Product____Model Number___

Attach a copy of the purchase receipt to this warranty card

Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.

New Zealand
PO Box 100707,
North Shore Mail Centre,
Auckland, 0745
www.goldair.co.nz

Australia
PO Box 574,
South Morang,
Victoria, 3752
www.goldair.com.au

References

• Goldair Australia
• Goldair Australia

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>