EBECO T-18 End Kit Instructions
- June 12, 2024
- EBECO
Table of Contents
EBECO T-18 End Kit Instructions
Included in the package:
-
Peel off 15 mm of the cable’s outer layer. Do not remove any of the grey insulation.
-
Bend back the earth braid or remove the aluminum foil and bend back the earth wire.
-
Apply some threads of glue to the cable so that it is easy to put the sleeve on.
-
Press out the air and fill with a little silicon glue; repeat until you have filled about 40 % of the sleeve.
-
Check visually that the cable is completely covered with silicone and that the cable is fully inserted.
WARNING! The use of silicone sleeves without glue is not approved. For interior installation, wait 1 hour before the water pipe is filled.
-
Check the insulation resistance when the work is finished. It must be at least 10 MΩ.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>