DIGITAL WATCHDOG DWC-VFHMW Hanging Mount for Vandal Dome Turret and Fisheye Cameras User Guide
- June 10, 2024
- DIGITAL WATCHDOG
Table of Contents
DIGITAL WATCHDOG DWC-VFHMW Hanging Mount for Vandal Dome Turret and
Fisheye Cameras
The hanging mount (model: DWC-VFHMW) is designed to mount Digital Watchdog cameras with various lengths of screws (20mm, 23mm, and 35mm) to a ceiling or an overhead surface.
WHAT’S IN THE BOX
- Mount cap with NTP 3/4 TAP
- Pipe mount cap
- M3.0x 20mm screws with washers (5 sets)
- M3.0x 23mm screws
- M3.0x 35mm screws
- Quick Setup Guide
NOTE:
Download all your support materials and tools in one place.
- Go to: http://www.digital-watchdog.com/resources.
- Search your product by entering the part number in the ‘Search by Product’ search bar. Results for applicable part numbers will populate automatically based on the part number you enter.
- Click ‘Search’. All supported materials, including manuals and quick start guides (QSGs), will appear in the results.
Installation
- Secure the hanging mount to the pole (NTP ¾ thread).
- Before attaching the camera to the hanging mount, remove the dome from the camera base.
- Pass wires through and make all necessary connections.
- Use the camera mounting screws (included with bracket) to secure the camera to the mounting cap. See the table below for the length of the screws and compatible cameras.
- Adjust the camera lens module’s position and secure the dome cover to the camera. See the camera’s Quick Start Guide (QSG) for camera setup information.
How to Determine the Correct Screw Size for Your Camera
If the camera’s mounting holes are located on the outer edge of the camera’s base, use the 20mm screws WITHOUT the washers. If the camera’s mounting holes are located on the inner edge of the camera’s base, use the 20mm screws with the rubber washers included.
NOTE:
For more information and support, visit digital-
watchdog.com/resources and search
for your product using the part number in the ‘Search by Product’ search bar.
All supported materials, including manuals and quick start guide (QSGs), will
appear in the results.
NOTE:
How to tell what MF, V8 or PVF hardware you have:
- If the camera’s mounting holes are located on the outer edge of the camera’s base, use the 20mm screws WITHOUT the washers.
- If the camera’s mounting holes are located on the inner edge of the camera’s base, use the 20mm screws with the rubber washers included.
Revision: 11/22
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
- Tel: +1 866-446-3595 / 813-888-9555
- digital-watchdog.com.
- Technical Support Hours: 9:00 AM – 8:00 PM EST, Monday through Friday
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>