Jimi IoT JM-LL01 LTE CAT M1 and NB2 Asset Terminal User Manual
- June 10, 2024
- Jimi IoT
Table of Contents
Jimi IoT JM-LL01 LTE CAT M1 and NB2 Asset Terminal
Product Overview
- GPS+WIFI + LBS positioning
- Real-time location query
- Geo-fence alert
- Tamper alert
- Cover remove alert
- Strong magnet mount
- 10,000mAh battery powered
- IP65 dust and water resistant
Specification
Product setup
- Find the notch and remove the upper cover and TPU part.
- Slide the retainer backward and rotate it up, and insert SIM card into it, then rotate it down and slide it frontward.
- Toggle the power switch to ON.
- Return the TPU part and the upper cover.
- Hold and press the power button (near battery display) to power on/off the device at your will.
Insert SIM
- Find the notch and remove the cover.
- Insert the SIM card into the card slot.
Initial use
- Toggle the battery switch beside the SIM slot to ON position.
Power on & off
- Hold and press the power button on one side of the device to power on or off the device.
Configuration
- If you need to change the setting of the device, you can either text the command to the device, or use APP tool.
- Note: Texting command might be filtered by local carrier network deployment. By APP tool please download and install the “Jimi loT Lab” through the following link. http://d.6short.com/nbr
- For iOS 9 and above Only
- Make sure the bluetooth is enabled on your iPhone, choose Connect on landing page.
- Power on the LL01 and then short press the power button for 3 times, the device name will automatically show on Connect page, tap on it to connect.
- After the device is connected successfully, you can view the basic data of the device, click the “Command mode” button at the bottom can enter the command setting page. Type and send the command to query and and make configurations. The device has no password by default, you can set password (See details in command list) to secure the device. If the password has been set, each command will need to be sent with the password filled. In the “Jimi loT Lab’ app landing page, you can create a template with multiple commands in Presets page, when the device is connected you can tap the “Upload preset” button instead to send multiple commands that you created in Presets at a time.
Common commnands
Standard parts list
Installation recommendation
- The device should face up to the sky.
- Metal thermal barrier or heating layer of the windshield affects the signal.
Troubleshooting
Warranty instructions
- The warranty is valid only when the warranty card is properly completed, and upon presentation of the proof of purchase consisting of original invoice indicating the date of purchase, model and serial No.of the product. We reserve the right to refuse warranty if this information has been removed or changed after the original purchase of the product from the dealer.
- Our obligations are limited to repair of the defect or replacement the defective part or at its discretion replacement of the product itself.
- Warranty repairs must be carried out by our Authorized Service Centre. Warranty cover will be void, even if a repair has been attempted by any unauthorized service center.
- Repair or replacement under the terms of this warranty does not provide right to extension or renewal of the warranty period.
- The warranty is not applicable to cases other than defects in material, design and workmanship.
Maintenance record
Documents / Resources
| Jimi
IoT JM-LL01 LTE CAT M1 and NB2 Asset
Terminal
[pdf] User Manual
JM-LL01, JM-LL01 LTE CAT M1 and NB2 Asset Terminal, LTE CAT M1 and NB2 Asset
Terminal, CAT M1 and NB2 Asset Terminal, M1 and NB2 Asset Terminal, NB2 Asset
Terminal, Asset Terminal, Terminal
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>