Shenzhen Jimi Iot 4G DashCam User Manual
- June 5, 2024
- Shenzhen Jimi Iot
Table of Contents
Jimi Iot 4G DashCam
User Manual
Please read this manual carefully prior to use.
The content of this manual may change due to improvements in the performance
of the product without prior notice.
Introduction
Overview
This 4G dashcam is a digital video recorder (DVR) that supports cloud storage
and can do the following: fix positions of a vehicle over both GPS and BOS,
communicate and live stream via the 4GL TE network, sense the orientation of
the vehicle, sync data using WiFi Direct, store images to the cloud, upload
data to the platform, and more.
It obtains power from the fuse box of the vehicle; therefore it is suitable
for most types of vehicles. It can provide locations, HD history video
footages, alert messages (about the collision, low battery, etc.), driving
behavior analysis, and other data to help fleet managers to know the condition
of their vehicles all the time, lower operation cost, and improve management
efficiency. It is not only suitable for commercial fleets, but also government
and enterprise fleets, private cars, e-hailing service cars, and taxis as well
as UBI service providers and auto financial services who would like to have
better visibility to their vehicles.
Features
- Communication over LTE network (Cat.1)
- High-precision position fixes using GPS and BDS and aided by AGPS and LBS
- Locally-stored 1080P history videos and 480P live videos
- Alert upon collision, vibrating during parking, ACC on or off, or other anomalies and upload related videos or images to the platform to facilitate the action-taking of operators
- Driving behavior analysis (UBI) such as harsh acceleration, braking, and cornering WiFi Direct enables drivers to watch history videos on their mobiles without consuming mobile data
- Cloud storage of locations (from real-time tracking), history trips, videos (from lifestreaming), event images, and short video clips
- Remote diagnosis
- OTA upgrade
- Open API for easy integration with a third-party platform
Appearance
Buttons| Short press: Mute/Unmute audio while recording|
---|---|---
Long press: Turn on/off WiFi
Short press: Start/Stop auto video recording (turn off temporarily)|
Short press: Take an image and upload|
Short press: Mute/Unmute the speaker|
Long press: Call the SOS number
LEDs| Solid on: Power on
0.3s-0.3s (on-off): SD card error or no SD card al s-i Os (on-off): Device in
sleep
Off: Power failure| Red (power)
Solid on: Position fixed
OA s-ls (on-off): Device searching for satellites 0.3s-0.3s (on-off): GPS
module error
Off: Sleep or power failure| Green (GNSS)
Solid on: Device online
O.ls-ls (on-off): Device searching for network 0.3s-0.3s (on-off): SIM card
error or no SIM Off: Sleep or power failure| Blue (Network)
SD card| Max. 128GB|
SIM card| Nano-SIM|
Basic Parameters
Feature| Description
UIS8910DM
---|---
Platform
Memory| 8MB+16MB
Operating system| RTOS
Network bands| EU: B1//133/B7/138/B20/1328
LA: B1/B2/B3/B4/135/B7/B8/1328/1366
Network standard| LTE Cat.1 bis
Location| GPS/BDS+AGPS+LBS
Lens| H>110°; D>135°
Video| 1920×1080@30fps, full-color
WiFi| 2.4G
Power supply| DC 9V-30V
Operating temperature| -20°C to 70°C
Packing List
When unpacking, please check whether the dashcam is in good condition and all accessories are included:
- Main unit xl
- Power cable xl
- Bracket xl
- 3M double-sided tape xl
- Fastening screw xl
Installation
Note:
- Use accessories specified by the manufacturer only.
- The standard supply range is 9-30V, please use the original power cable and ensure that the positive and negative are correctly wired.
- It is recommended to ask a distributor, a designated business, or an expert to do the installation and commissioning.
Preparation
- Check visually whether the device is in good condition and whether the relevant accessories are complete.
- Make sure that the device is ACC OFF before attaching or detaching the SIM or SD card.
Note:
-
Place a Nano-SIM (as the following figure shows) in the cardholder and insert them into the card slot.
Attention: Make sure the SIM has data service activated and is not in arrears. -
Use an SO card in speed class 10 or higher and with a capacity of 3268 or above.
-
4s the SD card has limited read and write cycles, it is recommended to replace it every half a year to ensure the recording performance of the device.
Bracket Installation
Mount the bracket to the device as the above figure shows and tighten the screw.
Cable and Power Connection
- As the above figure shows, route the power cable along the top edge of the front windshield and the A-pillar {both left and right will do) to the fuse box.
- Connect the GND, B+, and ACC wires of the power cable to the corresponding positions on the fuse box.
Other
After-sales Service and Disclaimer
-
please use the accessories provided by the manufacturer.
If any incompatible accessory is used, the warranty may become void. Such action may even pose danger to you and others.
We shall assume no liabilities for any damage or incidents resulting from the use of incompatible accessories. -
The warranty on product repair is void if you disassemble or tamper the enclosure of the product.
-
In pursuit of perfection and sustainable development, we may revise this user manual without notifying customers in advance.
-
This manual is prepared at the time when the product is manufactured. Unless otherwise stated by applicable law, we make no explicit or implicit guarantee for the correctness and reliability of the content in this manual.
-
To the fullest extent permitted by applicable law, in no case, the Company or the manufacturer shall be liable for any special, incidental, or indirect losses resulting from any cause.
FAQ
Device inactive
- Check whether the device can go online.
- Check the LEDs, the domain name, IMEI, SIM type, and statuses.
- Check the APN setting and the card read status by sending a message or making a call.
- Check whether the device can fix positions.
- The device is networked, goes online, locates successfully, and uploads location packets.
Device offline
-
If the device cannot go online when it is used for the first time, check the APN setting, SIM
card status, and the server address. -
If the device goes offline abruptly during use, check the SiM card status, the network status,
and the roaming condition.
Why the three LEDs do not light up and the device does not operate after the device is powered on?
- Check whether the ACC wire is correctly connected and the device is ACC ON. If not, set the ACC to ON.
- If the ACC wire is correctly connected and the red LED is still off, the device is not correctly powered. In this case, you need to check the power cable and the power supply.
Warranty Card
User Information
Name____
E-mail____
Address____
Phone number___
Postal code__
Product Information
Model____
Color____
SN____
Maintenance Record
| Record | Fault | Acceptance Date | Serviced By |
|---|---|---|---|