EZYmount SLT-360 Full Motion LED LCD TV Wall Mount Installation Guide
- June 10, 2024
- EZYmount
Table of Contents
SLT-360 Full Motion LED LCD TV Wall Mount
Installation Guide
SLT-360 Full Motion LED LCD TV Wall Mount
Installation Instructions
Full Motion LED, LCD TV Wall Mount
CAUTION: DO NOT EXCEED RATED LISTED WEIGHT. SERIOUS INJURY OR PROPERTY
DAMAGE k MAY OCCURI 
NOTE: Please read the entire instruction manual before you start
installation and assembly.
WARNING
- Do not commence installation until you have read and understood the instructions and warnings contained in this installation sheet. If you have any questions regarding any of the instructions or warnings, please contact your place of purchase.
- This mounting bracket was designed to be installed and utilised ONLY as specified in this manual. Improper installation or use of this product may cause damage or serious injury.
- This product should only be installed by someone of good mechanical ability, with basic building experience and full understanding of this manual.
- Make sure that the supporting surface (i.e. wall) will safely support the combined load of this bracket and all attached hardware (P.) and components.
- If mounting to timber wall studs, make sure that the mounting screws are anchored into the centre of the studs. Use of a stud finder is highly recommended.
- Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
- Tighten screws firmly, but do not over tighten. Over tightening can cause damage, greatly reducing their holding power.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Component Checklist
IMPORTANT: Ensure that you have received all pans according to the
component checklist prior to installation. If any pens are missing or levity.
telephone your local distributor fore replacement. 
la. Mounting on Timber Stud Walls
WARNING
- Make sure that mounting screws are anchored into the center of the studs. The use of a stud finder is highly recommended.
- Installers are responsible to provide hardware for other types of mounting situations.
- Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
lb. Mounting on Solid Brick and Concrete Block
WARNING
- When installing wall mounts on cinder block, verify that you have a minimum of 35mm of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 25mm minimum from the side of the block. It is suggested electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking outthe back of the hole when entering a void or cavity.
- The installer must verity that the supporting surface will safely support the combined load of the equipment and all attached hardware (TV) and components.
Attach Adapter Brackets
Position the adapter brackets
as close as possible to the middle of the screen. -) Screw the adapter
brackets onto the TV.
Tighton alt screws, but do not over tighton.
Hang TV on the Wall Plate
Make sure adapter brackets have
been securely hooked onto the wall plate before releasing the TV.
AdJustment
Maintenance
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
- Please contact your dealer if you have any questions.
Please dispose of this packaging in a responsible manner
– recycle cardboard/plastic wherever possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>