EZYmount CAN-PLB-2 Tilting wall Mount Instruction Manual

EZYmount CAN-PLB-2 Tilting wall Mount Instruction Manual

Tilting Wall Mount

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, contact your local distributor for a replacement

Package M

PackageW

NOTE: Please read the entire instruction manual before you start installation and assembly.

[](https://manuals.plus/wp-content/uploads/2023/04/EZYmount-CAN-PLB-2

-Tilting-wall-Mount-Instruction-Manual_3.png)WARNING

• Do not commence installation until you have read and understood the instructions and warnings contained in this installation sheet. If you have any questions regarding any of the instructions or warnings, please contact your place of purchase.
• This mounting bracket was designed to be installed and utilised ONLY as specified in this manual. Improper installation or use of this product may causedamage or serious injury.
•  This product should only be installed by someone of good mechanical ability, with basic building experience and full understanding of this manual.
•  Make sure that the supporting surface (i.e. wall) will safely support the combined load of this bracket and all attached hardware (TV) and components.
•  If mounting to timber wall studs, make sure that the mounting screws are anchored into the centre of the studs. Use of a stud finder is highly recommended.
•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage, greatly reducing their holding power.
•  This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

1a. Mounting on Timber Stud Walls

[

](https://manuals.plus/wp- content/uploads/2023/04/EZYmount-CAN-PLB-2-Tilting-wall-Mount-Instruction- Manual_7.png)

WARNING

• Make sure that mounting screws are anchored into the centre of the studs. The use of a stud finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined weightof the equipment and all attached hardware and components.

1 b. Mounting on Solid Brick and Concrete Block

[](https://manuals.plus/wp-content/uploads/2023/04/EZYmount-CAN-PLB-2

-Tilting-wall-Mount-Instruction-Manual_3.png)WARNING

• When installing wall mounts on cinder block, verify that you have a minimum of 35mm of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 25mm minimum from the side of the block. It is suggested electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.

2. Installing the Vertical Rails

2-1 For Flat Back Screens

2-2 For Recessed Back Screens or to Access AN Inputs

3. Hanging the TV onto the Wall Plate

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>