HEARTH HOME ODCTGWD-FSK36 Extended Smoke Shield Installation Guide

June 9, 2024
HEARTH HOME

HEARTH HOME ODCTGWD-FSK36 Extended Smoke Shield

Extended Smoke Shield for ODCTGWD-FSK42 ODCTGWD-FSK36

These smoke shields have been tested for use with specific Hearth & Home Technologies Inc. fireplaces. Check with your local building code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you, please visit www.hearthnhome.com.

Note : An arrow found in the text signifies a change in content
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during installation. Sheet metal edges are sharp.

INSTRUCTION

HEARTH-HOME-ODCTGWD-FSK36-Extended-Smoke-Shield-FIG-
\(1\)

  • Remove the screens and rods from the fireplace (each secured by one screw) and set them aside.
  • Remove the screws holding the smoke shield on the fireplace.
  • If the U.L. label is on the existing smoke shield it must be removed using a 1/8 in. drill bit to drill out the rivets.
  • Screw the U.L. label to the new smoke shield with the screws provided.
  • Install the new smoke shield. Seal the ends of the smoke shield with high temp sealant around the sides/top of the side refractory.
  • Replace the screens.

Hearth & Home Technologies Inc.
Extended Smoke Shield
4108-971 Rev A
05/22

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HEARTH HOME User Manuals

Related Manuals