IZZY IZ-8004 Electric Oven 42lt Instruction Manual
- June 9, 2024
- Izzy
Table of Contents
- Safety interlocks
- Parts of the Appliance
- Before the First Use
- How to Use the Oven
- How to Use the Hotplates (Large & Medium Hotplates)
- How to Use the Small Hotplate
- Care and Cleaning
- Technical Characteristics
- Guarantee & Customer Service
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
IZZY IZ-8004 Electric Oven 42lt Instruction Manual
Safety interlocks
Please read these instructions carefully before using the appliance and save them for future reference. Please keep the sales receipt for guarantee purposes (pls see below “Guarantee and Customer Service”) Any use which does not conform to the instructions will absolve IZZY from any liability.
- Before connecting the appliance, check if the voltage indicated on the appliance, corresponds with the mains voltage in your home.
- Always plug your device into an outlet that is earthed. Failure to comply with this requirement may result in electric shock and possible serious injury.
- Never leave the appliance unattended when in operation.
- Close supervision is necessary when your appliance is being used near children. Ensure that they do not play with the appliance.
- This appliance is not intended for use by people with reduced physical, sensory or mental capabilities, children or those with lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Disconnect the power cord from the supply mains:
- When you do not use the appliance
- Before cleaning and maintenance operations
- Never use the appliance for any other use than indicated.
- The device is intended for indoor use. Do not use the device outdoors.
- Do not store the appliance outdoors.
- The device is intended only for domestic use. Any other use will cancel the warranty.
- Check the power cord periodically for possible damages. If the power cord or the plug of the appliance has been damaged, do not use the appliance and contact an authorized BENRUBI Service Center.
- Make sure that the power cord does not come into contact with the hot parts of the appliance or comes into contact with sharp corners.
- Do not place the appliance near heat sources, on or next gas or electric hobs.
- Always use the appliance on a dry, flat surface, resistant to high temperatures.
- Do not operate or place the device or parts in places of high humidity or where it may get wet. Do not immerse the appliance in water or any other liquid.
- The appliance should not get in contact with flammable material, as curtains, draperies, walls and the like, when in operation.
- Only use metal pans or heat-resistant glass pans.
- Do not place any of the following materials in the oven: cardboard, plastic, paper, or anything similar.
- Do not store any materials other than manufacturer’s recommended accessories in this oven when not in use.
- Always use the appliance on a dry, flat surface, resistant to high temperatures. Particular attention is required on surfaces where the temperature can cause problems. In these cases, it is recommended to use additional heat-resistant surface.
- Do not pour cold water on the tray or in the oven while the device surface is still hot. The device surface may get damaged as a result of rapid heat changes and lead to personal injuries.
- Any error in connection cancels the warranty.
- Do not place the oven inside or under cabinets. You should not build in the oven.
- Use your device for cooking or heating food only. Do not use the device and its accessories for other than the appropriate or recommended use by the manufacturer.
- Do not attempt to operate the oven with the door open.
- Do not cover the appliance or place any objects above.
- The oven must have sufficient air flow. Keep at least 10cm space at the back, 5cm from the sides and 100cm from the floor.
- An additional ventilation may be required as a result of heavy use of the device for an extended period, for example: opening a window or more effective ventilation or increasing the mechanic ventilation systems if exists.
- If smoke is observed, switch off or unplug the appliance and keep the door closed in order to stifle the flames.
- Never use highly corrosive or abrasive cleaning agents
- The oven should be cleaned regularly and any food deposits should be removed.
- Failure to maintain the oven clean could lead to deterioration of the surface that could adversely affect the life of the appliance and possibly result in a hazardous situation.
- Avoid scratching door surface or nicking edges. Attention: The surface of the oven is hot during operation. Attention: Do not operate the oven when it is empty.
- This appliance is not intended to be operated by means of an external timer or separate remote-control system.
- The door or the outer surface may get hot when the appliance is operating.
- Never leave the power cable wrapped during use. Unwind it completely.
- Do not move the appliance when it is in operation.
- Do not press the door with heavy materials, do not lean or place heavy materials on the door while the oven door is open or do not carry by holding the oven door.
- Please ensure the device is unplugged before replacing the device lamp to prevent being exposed to a possible high voltage.
- Do not touch the appliance with wet or damp hands.
- If the appliance does get wet, immediately remove the power cord from the wall outlet and contact one of the authorized BENRUBI service centers.
- In case of a possible damage, do not attempt to repair the appliance by yourself. Please contact one of the authorized BENRUBI service centers. Any repair made by an unauthorized BENRUBI Service Center CANCELS THE GUARANTEE.
- Any misuse of the device cancels the warranty.
- Only use original spare parts.
- The appliance conforms to EU directive 2014/30/EU on Electromagnetic Compatibility, the 2014/35/EU Low Voltage Directive, the 2011/65/EU RoHS Directive, the directive 2009/125/ EC for ecodesign and the EC regulation no. 1935/2004 on materials intended to contact with food.
Parts of the Appliance
- Control panel
- Oven frame
- Handle
- Vessel
- Heaters
- Oven feet
- Glass oven door
- Control knobs
- Round tray
- Square tray
- Rack
- Hotplate
CONTROL PANEL
| Large hotplate adjustment knob Adjust the temperature of the large hotplate
by turning the knob clockwise to select the desired temperature (1 – 3)
depending on the food of your choice
---|---
| Medium hotplate adjustment knob Adjust the temperature of the medium
hotplate by turning the knob clockwise to select the desired temperature (1 –
3) depending on the food of your choice.
| Oven temperature adjustment knob Set the oven temperature by turning
clockwise the knob to select the appropriate temperature according to the food
of your choice. The gradation of temperature is from 90℃ to 230℃.
| Heater selection knob
Upper heater
Lower heater
Upper and Lower heater
| Small hotplate button (On/Off)
Note:
- Please note that the large hotplate cannot operate along with the oven.
- Μedium and small hotplates can operate along with the oven.
- Υou may operate all three heaters concurrently, but not along with the oven.
Install this oven only in accordance with the installation instructions provided.
- Make sure that all the packaging materials are removed.
- Inspect the oven after unpacking for any visual damage such as misaligned or damaged door, dents or holes in the door window, dents in the cavity. If any of the above are visible, DO NOT INSTALL the oven and contact the dealer immediately.
- Place the device on a stable, flat surface. Minimum installation height: 100 cm.
- The oven must have sufficient airflow. Leave more than 10 cm from the rear, 5 cm gap from the side.
- Do not place the oven in or under cabinets.
- When you choose where you will install the oven, make sure it is away from hot air, steam or where it might get wet, otherwise the oven function may be affected.
- Make sure the oven door opens freely without being restricted by any objects.
- Do not place any object on the oven. Follow all the necessary ventilation conditions. If the device is not ventilated properly during operation, it may overheat and eventually fail.
- Do not remove the legs from the bottom of the device.
- Do not cut off the mains plug because the device is not designed for permanent connection to the mains.
Attention: The rear surface of the appliance should be put against the wall.
Before the First Use
NOTE: Smoke and odors may occur on the first use.
Ensure that all 4 switches are set to “•” and the small hotplate button to “O” position.
- Clean the parts with hot water and soap. Rinse and dry the components thoroughly (see section “Care and Cleaning”). Wipe the inside of the oven with a dry cloth.
- Plug the device into the socket.
- Turn clockwise the oven temperature adjustment knob to 230oC and the heater selection knob
- to “ ”. The power indicator light will turn on.
- Keep the oven on without any food for 15 minutes. This is done to eliminate any packing residue that may have remained.
- After the 15 minutes turn both the oven temperature adjustment and the heater selection knobs to “•” position. The power indicator light will turn off.
- Unplug your device from the mains.
How to Use the Oven
Ensure that all 4 switches are set to “•” and the small hotplate button to “O” position.
- Plug your device into the wall socket.
- ]Turn the oven temperature adjustment knob clockwise to the desired temperature (40℃ – 230℃).
- Turn the oven function knob clockwise to the desired function (upper heating element, lower heating element, upper-lower heating elements). The power indicator light will turn on.
- Place the rack and pan with the food at the desired height into the oven.
- When finished cooking, turn both knobs to “•” position. The power indicator light will turn off.
- Remove the pan from the oven. CAUTION: Always use special oven mitts.
- Unplug the device from the mains.
Notes:
- Do not touch the heating element while operating the oven.
- Do not place food that touches or is too close to the upper heating elements.
How to Use the Hotplates (Large & Medium Hotplates)
- Plug the device into the socket.
- Turn clockwise the large/medium hotplate adjustment knob to the desired temperature setting (1-3). The power indicator light will turn on.
- Place the pot/s on the hob/s.
- When finished cooking, turn the large/medium hotplate adjustment knob to “•” position. The power indication light will turn off.
- Remove the pot/s from the hotplate/s. CAUTION: Always use special oven mitts.
- Unplug the device from the mains.
Note:
- The large hotplate can not operate along with the oven.
How to Use the Small Hotplate
- Plug the device into the socket.
- Push the small hotplate button to “I” position. The power indicator light will turn on
- Place the pot on the hob.
- When finished cooking, push the small hotplate button to “O” position. The power indicator light will turn off.
- Remove the pot from the hob. CAUTION: Always use special oven mitts.
- Unplug the device from the mains.
Note:
- The small hotplate operates when the large and/or medium hotplate(s) are turned on
Care and Cleaning
Warning: Be sure to unplug the oven and cool it before cleaning
- Wipe inside the oven with a damp sponge, cloth or nylon scouring pad with mild detergent. All accessories should be washed in hot soapy water. The glass door can be wiped with a damp sponge and wiped dry with a paper or cloth towel. Clean the outside with a damp sponge. Wipe the baking tray, wire rack and tray handle with absorbent paper, a towel or a soft cloth.
- Never immerse the appliance in water or any other liquids for cleaning. Store the appliance in a safe clean p
DO NOT USE ABRASIVE CLEANING AGENTS!
This allows cleaning of the dirt that is softened by the steam created inside the oven without using chemicals.
- Remove all accessories from the oven. Put 2 glasses of water inside the square tray and place the tray to the bottom shelf.
- Bring the oven temperature adjustment knob to steam cleaning mode .
- Bring the switch to lower resistance mode .
- After operating the oven for 30 minutes turn the knobs to position “•”, open the door and wipe the inner surface of the oven with a damp cloth.
Technical Characteristics
Model: Oven with 3 hotplates IZ-8004
Outer width: 52 cm
Outer depth : 44 cm
Outer height: 36 cm
Inner width : 40 cm
Inner depth: 39 cm
Inner height: 24 cm
Thermostat: 40 – 230 °C
Bottom heater: 650 W
Top heater: 650 W
Supply voltage: 220-240V~50/60Hz.
Total Power: 4250W
Capacity: 42Lt
Hotplates:
- Large hotplate: ø180 HP, 1500W
- Medium hotplate: ø145 HP, 1000W
- Small hotplate: ø 80 HP, 450W
Important information for correct disposal of the product in accordance
with EC Directive 2002/96/EC
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household device separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources.
As a reminder of the need to dispose of household devices separately, the product is marked with a crossed-out wheeled dustbin.
Guarantee & Customer Service
- BENRUBI Company guarantees its products for any manufacturing defect or defective materials for a period of two (2) years from the date of purchase or delivery by presenting purchase receipt. If your product malfunctions or you find any defects, please revert to the retail location you have purchased it from or contact an authorized BENRUBI Service Centre. To find the nearest authorized BENRUBI Service Centre, visit our website www.benrubi.gr. It is in the discretion of BENRUBI Company to replace or repair the defective product.
- The warranty does not cover damages resulting from normal wear, breakage, scaling, improper installation or maintenance of the product, mishandling, abnormal working conditions, failure to implement the instructions, conversion or repair of the product by an unauthorized technician who does not belong to the BENRUBI Service Centers.
Also, the warranty does not cover the following indicative factors:
- Stains, discoloration or scratches.
- Burns due to exposure to heat or flame.
- Damage from thermal shock (sudden temperature change or change of voltage).
FOR MORE INFORMATION PLEASE CONTACT:
(NEW) H. BENRUBI & FILS SA
27 Aghiou Thoma str, GR15124, Maroussi – Athens,
Tel.: +30210 6156400
e-mail: benrubi-sda@benrubi.gr
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>