SEKONIC C-7000 SpectroMaster Color Meter User Guide
- October 30, 2023
- SEKONIC
Table of Contents
C-7000 SpectroMaster Color Meter
SEKONIC Spectrometer
C-7000
Startup Guide
Thank you for purchasing a spectrometer C-7000.
This Startup Guide introduces the basic operations of this product. For details about how to use this product, please see the Operating Manual on the CD-ROM (included with the products).
1. Download
2. Check Included Items
The following items are included with the meter in the package. Please be sure to check that all noted items are included.
★ If any items are missing, please contact the distributor or the reseller you purchased the meter from.
★ Batteries (2 AA) are not included in the package. Please obtain these separately.
1.888.610.7664www.calcert.com sales@calcert.com
3. Names of Parts
4. Turning the Power ON/OFF
After installing the batteries, turn the Light Selection Ring ❷ to the dark
calibration position CAL ( ) and turn ON this instrument by pressing
the Power Button ❸ .
After the Opening screen displays (for 2 seconds) in the Display Panel,
dark calibration starts. After dark calibration properly ends, the Display
Mode Selection Screen displays.
★ You can reduce start up time by simply tapping the screen when the Opening
screen appears.
★ Please wait 3 or more seconds between turning the power ON/OFF.
★ To turn OFF the power, press and hold the Power Button for more than one
second. The meter is powered off after the display disappears.
★ If Dark Calibration Position Confirmation screen appears, set the Light
Selection
Ring ❷ to Dark Calibration position and perform calibration again.
Dark Calibration Position
Confirmation Screen
-
If “Please set Light Selection Ring for dark calibration” is displayed, set the Light Selection
Ring ❷ to the dark calibration position to start calibration. -
When taking measurements, set the Light Selection Ring ❷ to the range L (icon at the
middle) for ALL ambient light. For flash light, set the ring to “H” (icon at the
top) high-power (brighter than 640lx·s) flash
or “L” (icon at the middle) for low-power flash
(lower than 640lx·s).
NOTE.
Dark calibration is performed when new batteries are set, 24 hours passed
since last use or there is a big change in temperature between turning power
OFF and ON again.
Except the cases above, dark calibration after power ON is skipped.
5. Measuring Mode and Display Mode
You can change screens after turning the power on as follows.
Changes from the Display Mode Selection Screen to the Measuring
Screen.
★ Pressing Menu Button ❻ shifts to the Display Mode Selection screen.
6. Tool Box
Touching the “Tool Box ( )” icon in any
measurement screen shifts to the Tool Box screen
where frequently used functions are listed.
7. Setting
Touching the “Setting” icon in the Display Mode
Selection screen shifts the display to the Setting
screen.
Here you can set functions and display methods
required for measurement in advance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>