BABYLISSPRO BP331SUC Professional Triple Barrel Waver Instruction Manual
- June 12, 2024
- BaBylissPRO
Table of Contents
- BABYLISSPRO BP331SUC Professional Triple Barrel Waver
- Product Information
- Product Usage Instructions
- IMPORTANT SAFETY INSTRUCTIONS
- OPERATING INSTRUCTIONS
- GET TO KNOW YOUR TRIPLE BARREL WAVER
- USER MAINTENANCE
- FEDERAL COMMUNICATIONS COMMISSION NOTICE
- SUPPLIER’S DECLARATION OF CONFORMITY
- HASSLE-FREE 3-YEAR WARRANTY
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
BABYLISSPRO BP331SUC Professional Triple Barrel Waver
Product Information
The Triple Barrel Waver is an electrical styling appliance designed to create waves in the hair. It features a special protective application and has a Porcelain Ceramic barrel technology for even heat distribution.
It is important to follow the safety instructions provided to ensure safe usage of the appliance. The Triple Barrel Waver has dual voltage capabilities and will automatically adjust to the proper voltage. An adapter plug with the correct configuration should be used when using the appliance in an outlet.
Product Usage Instructions
- Ensure that you have read all the safety instructions before using the Triple Barrel Waver.
- Choose the appropriate temperature setting for your hair type by turning the temperature regulator dial. Refer to the temperature settings chart provided in the manual.
- Comb or brush a 2-inch wide section of hair, starting from the scalp and working towards the ends.
- Open the iron and gently clamp the hair strand close to the scalp, weaving the hair under and over the three barrels.
- Close the iron and hold it in this position for 8 to 12 seconds, depending on your hair type. Hold for 8 seconds for fine hair and up to 12 seconds for medium to coarse hair.
- To release the hair, simply lift the marcel/spring handle.
- If desired, repeat the process on other sections of hair until you achieve the desired amount of wave.
It is important to note that the Triple Barrel Waver can become extremely hot when used at its highest setting. Take extra care to avoid contact with eyes or bare skin. Do not place the heated appliance directly on any surface while it is hot or plugged in. Use the built-in safety stand.
During initial use, the Triple Barrel Waver may emit smoke, which is caused by the burning off of the protective application on the heating element. This smoke is not harmful and will quickly disappear.
For best results, it is recommended to use superior quality shampoos, conditioners, and finishing products to maintain your hair’s health.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic
safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
KEEP AWAY FROM WATER.
DANGER – Any appliance is electrically live even when the switch is off.
To reduce the risk of death by electric shock:
- Always unplug it immediately after using.
- Do not use while bathing or in the shower.
- Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not place in or drop into water or any other liquids.
- If an appliance falls into water, unplug it immediately. Do not reach into the water.
WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:
- This appliance should never be left unattended when plugged in.
- Close supervision is necessary when this appliance is used by, on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use, as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or dropped into water. Return the appliance to an authorized service center for examination and repair.
- Keep the cord away from heated surfaces. Do not pull, twist, or wrap line cord around appliance.
- Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the airopenings free of lint, hair and the like.
- Never use while sleeping.
- Never drop or insert any object into any opening or hose.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord with this appliance.
- This triple barrel waver is hot when in use. Do not let eyes or bare skin touch heated surfaces.
- Do not place the heated triple barrel waver directly on any surface while it is hot or plugged in. Use the built-insafety stand.
- Before plugging in, read the information about dual voltage contained in the DUAL VOLTAGE section of this manual.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
This appliance is intended for professional use. Use on Alternating Current
(50–60Hz) only. Standard appliances are designed to operate at 120–240V AC.
This appliance has a polarized plug (one blade is wider than the other). As a
safety feature, this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
IMPORTANT NOTICE
This styling appliance has a special protective application and the barrel
will be extremely hot when the temperature regulator dial is set at its
highest setting. Extra care should be taken when using. This product may emit
smoke during initial use. The smoke is not harmful and will quickly disappear.
It is only the protective application on the heating element being burned off.
DUAL VOLTAGE
This Triple Barrel Waver has dual voltage. It will automatically adjust to the
proper voltage. Use an adapter plug (not included) with correct configuration,
prior to use in outlet.
SUPER STYLING GUIDE
You look best with a good haircut that’s well-maintained. Always treat hair
right with superior quality shampoos, conditioners, and finishing products.
TRIPLE BARREL WAVER BASICS
- Plug the appliance into a standard electrical outlet (120–240V).
- Turn the temperature regulator dial to the setting that is appropriate for your hair type.
You can use the chart outlined below as a reference. The iron will heat up very quickly. TEMPERATURE SETTINGS| HAIR TYPE
---|---
230°F – 280°F| Very Fine Hair
281°F – 310°F| Easy-to-Curl Hair
311°F – 365°F| Textured Hair
366°F – 400°F| Curly Hair
401°F – 430°F| Very Thick Hair - Comb or brush a 2-inch wide wide section of hair. You will achieve the best results if you work from the scalp to the ends of your hair.
- Open the iron and gently clamp the hair strand close to the scalp, weaving the hair under and over the three barrels.
- Close the iron and hold the waver in this position for 8 to 12 seconds. Depending on type of hair, you may hold for 8 seconds for fine hair and up to 12 seconds for medium to coarse hair. To release, simply lift marcel/spring handle.
- The process may be repeated until you achieve the amount of wave you desire.
PORCELAIN CERAMIC
Your Porcelain Ceramic Triple Barrel Waver has many added benefits. The
Porcelain Ceramic barrel technology provides increased heat distribution,
eliminating the damaging hotspots found with other irons.
GET TO KNOW YOUR TRIPLE BARREL WAVER
NOTICE
THIS PRODUCT IS EQUIPPED WITH AN INSTANT HEAT CIRCUITRY. STATE-OF-THEART
TECHNOLOGY ALLOWS THE HEATER TO REACH THE OPERATING TEMPERATURE IN LESS THAN
ONE MINUTE. DO NOT LEAVE PRODUCT ON WHILE NOT IN USE. UNIT WILL BURN OUT IF
POWER IS KEPT ON FOR AN EXTENDED PERIOD OF TIME. WARRANTY WILL BE VOIDED. TURN
UNIT OFF WHEN NOT IN USE.
IMPORTANT
It is normal for any curling iron to accumulate dirt over time. Should your
barrel begin to get dirty, you may clean it as described below:
- Unplug the appliance
- Wait until it cools to room temperature
- Put a teaspoon of ordinary rubbing alcohol onto a soft cloth
- Wipe the barrel GENTLY to remove dirt
- DO NOT SCRUB
USER MAINTENANCE
Your iron is virtually maintenance free. No lubrication is needed. Keep all vents and openings clear of dirt and dust. If cleaning becomes necessary, disconnect the unit from the power source, and wipe exterior with a damp cloth. If any abnormal condition occurs, unplug the unit, allow it to cool, andreturn it for repair to an authorized service representative only. No repairs should be attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be pulled or twisted. Never wrap the cord
around the unit. Damage will occur at the high flex point of entry into the
unit, causing it to rupture and short. Inspect the cord frequently for damage.
Stop use immediately if damage is visible or if unit stops or operates
intermittently.
STORAGE
When not in use, your appliance is easy to store. Allow unit to cool, then
simply put back in the box, and store out of reach of children in a safe, dry
location. Do not jerk or strain cord at plug connections.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY
- Brand: BaBylissPRO®
- Model No.: BP331SUC
- Description: Triple Barrel Waver
- Responsible Party: Conair Corporation1 Cummings Point Road Stamford, CT 06902 203-351-9000
- Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 05/15/2021
WARNING:
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are a dangerous combination, but did
you know that an electrical appliance is still electrically live even if the
switch is off? If the plug is in, the power is on. So when you are not using
your appliances, keep them unplugged.
ALWAYS UNPLUG SMALL APPLIANCES.
For your safety and continued enjoyment of this product, always read the instruction book carefully before using it.
HASSLE-FREE 3-YEAR WARRANTY
This warranty is available only to consumers who purchase products directly
from BaBylissPRO or an authorized BaBylissPRO reseller. Except as otherwise
required under applicable law, this warranty is not available to retailers or
other commercial purchasers or owners or consumers who purchase from
unauthorized BaBylissPRO resellers. BaBylissPRO will repair or replace (at our
option) your unit free of charge for 36 months from the date of purchase if
the appliance is defective in workmanship or materials and was purchased
directly from BaBylissPRO or an Authorized BaBylissPRO Reseller. Your ultimate
satisfaction in BaBylissPRO products is our goal so if your item should fail
within the generous warranty period, we will repair it and or if necessary,
replace it at no cost to you. To obtain a return shipping label email us at
https://babylisspro.com/warrantypage. Or call our toll-free customer service
department at 800-326-6247 to speak
with a representative.
In the absence of a purchase receipt, the warranty period shall be 36 months
from the date of manufacture. ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 36-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an implied warranty lasts, so the
above limitations may not apply to you. IN NO EVENT SHALL BABYLISSPRO BE
LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do
not allow the exclusion or limitation of special, incidental, or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights,
which vary from state to state.
SERVICE CENTER
BaBylissPRO
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>