AGM G2 5G Smart Phone Instructions
- June 9, 2024
- AGM
Table of Contents
AGM G2 5G Smart Phone
BODY-WORN OPERATION
- This device was tested for typical body-worn operations with the back/front of the phone kept 0.5cm from the body.
- To comply with FCC RF exposure requirements, a minimum separation distance of 0.5cm must be maintained between the user’s body and the back/front of the phone, including the antenna.
- Third-party belt-clips, holsters and similar accessories containing metallic components shall not be used.
- Body-worn accessories that cannot maintain 0.5cm separation distance between the user’ s body and the back/front of the phone, and have not been tested for typical body-worn operations may not comply with FCC RF exposure limits and should be avoided.
- For more information about RF exposure, please visit the FCC website at www.fcc.gov
- Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it receives and also sends out radio frequency (RF) signals. In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones.
- Those guidelines are consistent with the safety standards previously set by both
- U.S. and international standards bodies:
< ANSIC95.1> (1992)/ <NCRP Report 86> (1986)/
- Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature. For example, over 120 scientists, engineers, and physicians from universities, government health agencies, and industry reviewed the available body of research to develop the ANSI Standard (C95.1).
- Nevertheless, we recommend that you use a hands-free kit with your phone (such as an earpiece or headset) to avoid potential exposure to RF energy. The design of your phone complies with the FCC guidelines (and those standards).
- Use only the supplied or an approved replacement antenna.
- Unauthorized antennas, modifications, or attachments could damage the phone and may violate FCC regulations.
NORMAL POSITION
Hold the phone as you would any other telephone with the antenna pointed up
and over your shoulder.
FCC RF EXPOSURE INFORMATION
WARNING: Read this information before using your phone In August 1986 the Federal Communications Commission (FCC) of the United States with its action in Report and Outer FCC 96-326 adopted an updated safety standard for human exposure to radio frequency (RF) electromagnetic energy emitted by FCC regulated transmitters.
- Those guidelines are consistent with the safety standard previously set by both
- U.S. and international standards bodies. The design of this phone complies with the FCC guidelines and these international standards.
- Use only the supplied or an approved antenna.
- Unauthorized antennas modifications, or attachments could impair call quality, damage the phone, or result in violation of FCC regulations.
- Do not use the phone with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor burn may result. Please contact your local dealer for replacement antenna.
RE Exposure Information
This product is compliance to FCC RF Exposure requirements and refers to FCC
website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for
FCC ID: 2A3DR-G2 to gain further information include SAR Values.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Do not use the device with the environment which below minimum -10°C or over maximum 50°C, the device may not work. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.
- Ad Hoc function is supported but not able to operate on non-US frequencies. Operation of this device is restricted to indoor use only.(W52 band)
- This device is acting as slave and operating in the 2.4 GHz (2412 ~2462MHz) band. Ad Hoc function is supported but not able to operate on non-Us frequencies.
- Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.
- This device is acting as slave and operating in the 2.4 GHz (2412~2462MHz) band. Ad Hoc function is supported but not able to operate on non-US frequencies.
Ad Hoc function is supported but not able to operate on nonUS frequencies. Operation of this device is restricted to indoor use only. (W52 band)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>