AGM 143 ASR Series ASR-03 Top-Racer Slot Car Set Instruction Manual

June 6, 2024
AGM

< Street challenge>
ASR-03 manual
Proper adult assembly required

Visit our website for more information
WWW.TOP-RACER.COM

Dear customer, thank you for your purchase. Please read the user manual carefully before use. Please retain the package for important service and safety information. You also can download E-manual from our website.
04.12.04.014
220311

Contents

Layouts

IASR-03 1st Layout I

Tips:
Use some guardrails around the corner to avoid running off track .

This indicates the “Loop” Please refer to the chapter of ‘Loop assembly’ to acquire its information

In the yellow areas below,
use 1 x
and some pieces for support under the track.

I ASR-03 2nd Layout I

Tips:
You can adjust the height of track supports to have a better racing experience.

Tips:
Use some guardrails around the corner to avoid running off track.

Accessor ies

The clips, guard rails, and bridge are fitted by tilting them upwards onto the edge of the track.
‘Contents and coleus may vary from shown above. No event accessory is included in this set.

Track support

Track assembly

Assembly

Join the track pieces together on a flat surface from pinpoint to pinhole. Disassembly

Press the circled areas below with both thumbs and pull track pieces apart.

IMPORTANT! Do not bend the track or pull the track pieces apart directly.

Loop assembly

First, we need to confirm the layout of 0 tracks. The layout is depended on the car’s running in and out direction.

Layout 1 is able to assembly loop as shown on

Layout 2 is able to assembly loop as shown on left. right.
Then, we use 2x 1, let the AGM Logo side be facing up. buckle them together.
And then, use this complex to buckle under e tracks. Try to let tracks’ edge be in a straight line.

|
---|---

Take layout 2 for example, we illustrate the following steps.

Use 8x racks, assembly together, make sure the track’s pinpoint connects with pinhole. Then connect with 110 tracks

After that, assemble the second loop and connect it with tracks. Also, make sure the track’s pinpoint connects with the pinhole.

Buckle 7x pointed places.

Assemble 2 supports. Use 7 pcs of , 1 pc of, and 1 pc of for each support.

Buckle 2 supports to the arrow-pointed places.

FCC ID: 2A4WJ-ASRGD001
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Important: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF warning for Portable device: The device has been evaluated to meet general RF exposure

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals