deli E3873 Comb Binding Machine User Manual
- June 9, 2024
- DELI
Table of Contents
deli E3873 Comb Binding Machine
Thank you for purchasing No.3873 rubber ring binding machine of Deli Company. The multiple functions and elegant design make the product applicable to individual use and department use. We believe that the rubber ring binding machine with complete functions will make your document binding have higher efficient. To make you correctly use the product and prevent the inconvenience caused to you and other people, please carefully read this manual.
Product apparent structure and the names
Direction for use
- The machine is used for punching of paper and plastic sheets, and a plastic clip is used for loose-leaf binding. The machine only can be used for this purpose, and please use it according to the operation instruction.
- Before punching of the original materials, do remember to use waste paper to test whether the machine works normally.
- Empty the waste container periodically.
- The upper limit number for punching is 18, and this number shall not be exceeded.
- Insert paper and adjust the “limit block” to centre the paper. Select adjustable cutters to set hole punching.
- Pull down the handle to punch holes, then lift back to the original place.
- Place the plastic rings to the back of comb opening upward.
- Push the handle backward and let the hooks engage the rings to open the plastic rings.
- Insert the bonded paper into the plastic rings.
- Push the handle backward and finished of the text.
Common fault analysis and troubleshooting
Fault phenomenon| Fault cause analysis| Troubleshooting
method
---|---|---
It is hard to press the handle when paper punching
| There is paper scrap or another hard object in the paper-cutting port| ****
Take out the sundries with chipboard.
The operation is beyond the punching capacity described in the instruction.| Operate according to the requirements of the instruction.
The punching edge distance has an inclination phenomenon.
| The two sides of the incoming paper are unbalanced.| The two sides of the
incoming paper are unbalanced.
There is paper scrap or another hard object in the paper-cutting port.| ****
Take out the sundries with chipboard.
The open rubber ring has an inclination phenomenon.
| The comb plate has deformation caused by collision.| ****
Straighten the comb plate with a ruler.
The draw hook of pull ring plate has deformation.| Pull the pull ring to
calibrate the draw hook with hands.
Incomplete paper punching or the paper is hard to draw out.| ****
The number of pieces of paper for punching at a time is too large.
| Reduce the punching thickness of each time (based on the requirements of the
instruction)
The paper cannot reach the bottom.| The paper is unserviceable and the paper
edge coils.| Smoothen the paper and then re-operate.
Product parameters
- Maximum punching thickness: 18 pieces of paper (70g-A4 paper)
- Margin Adjustable: 2.5-6.5 mm
- Distance between holes: 14.3mm
- Binding specification: A4 paper or below
- Maximum binding thickness: 425 pieces
DELI GROUP CO.,LTD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>