Cudy M1800 Whole Home Mesh WiFi System Installation Guide
- June 9, 2024
- cudy
Table of Contents
Cudy M1800 Whole Home Mesh WiFi System Installation Guide
Connecting
- Power off your modem
- Connect Port #1 of Cudy to your modem’s LAN port.
- Power on the modem and wait about 2 minutes for it restart.
- Power on Cudy and wait about 1 minute until the system LED changes from flashing to solid on(red or white).
Connect your computer to the router (Wired or Wireless)
Wired
Turn off the Wi-Fi on your computer and connect it to router’s Port #2 via an ethernet cable.
Wireless
Connect your device to the router’s Wi-Fi using the SSID (network name) and
Password printed on the bottom of the router.
Launch a web browser, and enter http://cudy.net/ in the address bar. Use
admin for password to log in.
Note: If the login window does not appear, please refer to FAQ > Q1.
Then below popup will appear, please follow step by step instructions to set up the internet connections.
When all the configurations are completed, the router will restart. Wait for the LED to turn solid white, which means that the configuration is successful and connected to the Internet.
Note: If the pop-up window does not appear, please click Quick Setup on the status page.
Add more mesh units
Power on the add-on mesh unit, waiting for its system LED becomes solid on.
Within 2 minutes, press the pair button of both the add-on mesh unit and the main mesh(the one you already configured).
Waiting for the system LED of the add-on unit becomes solid white, means successfully.
Note: For other LED status, please check the LED status explanation.
Or you can contact our support team
support@cudy.com
LED Explanation
| LED Status | Main Mesh | Add on Mesh |
|---|---|---|
| Red | Flash | Starting up |
| Solid | System ready, no internet | System ready, not connected to main mesh |
| White | Flash | Pairing |
| Solid | Connected to internet | Connected to main mesh, signal good |
| Red White Red | N/A | Pairing |
Button Explanation
| Button | Press and hold 1 second to start pairing. | |
|---|---|---|
| Reset | Press and hold 6 seconds to reset the router to its factory default |
settings.
Frequently Asked Questions (FAQ)
Q1: What can I do if the login window does not appear?
A1: If the computer is set to a static IP address, change its settings to
obtain an IP address and DNS server address automatically.
A2: Verify that http://cudy.net/ or 192.168.10.1 is correctly entered
in the web browser .
A3: Use another web browser and try again.
A4: Reboot your router and try again.
A5: Disable and then enable the network adapter being used.
Q2: What should I do if i can not find Wi-Fi signal?
A: Please make sure the router is connected, power and broadband interface has no loose. If everything is normal but still no signal, please try to use computer to set, or restore the router to factory settings. If after restoring factory settings but still no signal, you can restart the router, if it still doesn’t work, maybe the router has fault.
Cudy hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU,
2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at
http://www.cudy.com/ce.
Email: support@cudy.com
Driver & Manual: www.cudy.com/download
If your internet connection is through an ethernet cable directly from the wall instead of through a DSL/Cable/Satellite modem, connect the ethernet cable to the router’s Port #1, and skip steps 1, 2 ,3.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>