JTS ur816d Instruments Dedicated Wireless Microphone100m Electric Guitar Instruction Manual

June 9, 2024
JTS

JTS ur816d Instruments Dedicated Wireless Microphone100m Electric Guitar Instruction Manual
JTS ur816d Instruments Dedicated Wireless Microphone100m Electric
Guitar

Important Caution

  • Always make all connections before plugging the unit into an AC power outlet.
  • Do not leave the devices in a place with high temperature or high humidity.
  • Do not handle the power cord with wet hands!
  • Keep the devices away from fire and heat sources.
  • This is a general user’s manual. To check out standard accessories please find them on the product packing box

Features

UT-16GT/UT-16GTP provides true wireless experience to musicians. Within limited space it delivers uncompromised features.

  • Innovative combo design good for guitar , accordion , winds & brass
  • UHF PLL 16 channels
  • At least 60 meter operation distance
  • Tone Key Squelch
  • Higher signal to noise ratio
  • One AAA 1.5V battery runs for 8 hours

Specification

Receiver// UR-816D (DB)

Frequency Preparation…

Carrier Frequency Range
S/N Ratio………………..
T.H.D…………………….
Display…………………..
Display Contents………..
Controls………………….
Audio Output Level…….
AF Output Impedance….
Squelch…………………..
Operation Voltage ………………..
Output Connector…..
mension(m/m)…

Parts Identification & Accessories

Receiver// UR-816D(DB)

Front panel

  1. Antenna

  2. Power On/Off Switch

  3. Power LED

  4. Channel selector

  5. RF indicator

  6. AF indicator

  7. Volume control
    Rear panel

  8. Power Supply Jack (12-18V/200mA): for connecting the power supply unit.

  9. Strain Relief: for the connection cable of the power supply unit, which leads the cable around the hook to prevent accidental disconnection of the plug from the jack.

  10. AF Output (6.3mm jack, unbalanced): for connection to a unbalance input, e.g. of a mixer or amplifier.

  11. Balanced XLR Output: for connection to the balanced input, e.g. of a mixer or an amplifier.

  12. Output Level Attenuation(-20dB): to attenuate the balanced XLR output level by -20dB.

Miniature Transmitter
  1. UT-16GT/UT-16GTP
  2. Power On/Mute/Off switch
  3. LED indicator for power On/Off, battery status and mute
  4. Channel selector
  5. Input gain
  6. Antenna
  7. 6.3GT plug : Jack plug
  8. 516GT: Accordion microphone module 508GT: Winds & Brass microphone module.
  9. 16GT Adapter
  10. 516 Bracket
  11. 16GT Clip: Winds clip
  12. Battery Lid (Color ID): Orange / White / Silver included
  13. CLP-UT

Guitar Pack
Miniature Transmitter
Guitar/Winds Pack
Miniature Transmitter
Winds/Brass Pack

Accordion/Guitar Pack
Miniature Transmitter

Rack Mounting

  1. Before mount receivers onto DR-900 rack adaptor, please release any cables from the rear of the receiver.

  2. Turn over receiver and DR-900 rack adaptor simultaneously, there are 4
    threaded holes at the bottom of receiver and rack adaptor for inserting screws.

  3. Single receiver Insert in a receiver through the front of DR-900 until it is firmly attached to the rack, then screw on a RP-900 to another side of the rack.

  4. Dual receivers The same way as above, put one receiver to each rack space.
    Rack Mounting

Recommendation

  1. In order to achieve the optimum reception condition and also extend the operating distance, please leave on “open space” between the receiver and transmitter.
  2. Keep the devices away from the metal objects or any interference sources at least 50 cm.
  3. To avoid the feed-back effect, don’t leave the mic. to aim at the speakers directly.
  4. Remove batteries from the battery compartment when the transmitter will not be used for a long time.

Important Notice

  1. JTS offers wireless systems in a selection of bands that conform to the different government regulations of specific nations or geographic regions. These regulations help limit radio frequency (RF) interference among different wireless devices and prevent interference with local public communications channels, such as television and emergency broadcasts.
  2. For information on bands available in your area, consult your local dealer or phone JTS. More information is also available at JTS’s website (www.jts.com.tw).
  3. This Radio apparatus may be capable of operating on some frequencies not authorized in your region. Please contact your national authority to obtain information on authorized frequencies and RF power levels for wireless microphone products.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals