ventair WAL45-DC 45cm Heavy Duty Oscillating Wall Fan Instruction Manual

ventair WAL45-DC 45cm Heavy Duty Oscillating Wall Fan Instruction Manual

CAUTION Read Instructions Carefully For Safe Installation and Fan Operation

THANK YOU FOR PURCHASING

Thank you for purchasing this quality Ventair cooling fan. To ensure correct function and safety, please read all instructions before using the product and keepall instructions for future reference.

WARNING
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electrical shock and personal injury.

1. Use this fan only as described in this manual. Other use not recommended may cause fire, electric shock or injury to persons. This will also void your warranty.

2. Always operate the product from a power source of the same voltage, frequency and rating as indicated on the rating label.

3. This product is intended for household and indoor use ONLY. Do not use it outdoors or anywhere it might be exposed to the elements.

4. To protect against electric shock: do not immerse unit, plug or cord in water or spray with liquids; do not place fan on windowsills or other places where it may be exposed to dripping or splashing of water; do not place vases or similar objects filled with liquids near the fan.5. Do not use this product in  the immediate vicinity of water, such as bathtubs, washbowls, swimming pools etc. where the likelihood of immersion or splashing could occur.

5. To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.

6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

7. This product is not a toy! Children should be supervised to ensure that they do not play with the appliance.

8. When the appliance is not in use and before cleaning, unplug the appliance from the outlet. Fully assemble the fan before switching on again.

9. To disconnect the fan, first turn the unit OFF, grip the plug and pull it from the wall outlet. Never pull the plug by the cord.

10. Do not operate the fan in the presence of explosive and/or flammable fumes.

11. Do not place the fan or any parts near an open flame, cooking or other heating appliance.

12. Do not operate fan with a damaged cord or plug, or if the product malfunctions, or is dropped or damaged in any manner.

13. Avoid contact with moving fan parts. Do not insert any body parts (e.g. finger) or objects through the grille when the fan is operating.

14. The use of attachments not recommended by the manufacturer may be hazardous.

15. Place the fan on a dry, level surface to avoid overturning.

16. Do not operate if the fan housing is damaged.

17. Do not cover the grille, or operate in close proximity to curtains, etc. Ensure adequate ventilation around the unit.

18. A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified technician to replace loose or worn outlet.

19. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard.

20. WARNING: The flexible supply cord connected to this fan shall be effectively fixed to the wall.

21. If the fan is not working properly, contact a qualified technician for examination and repair. Never attempt to dismantle the fan yourself.

22. Never install or store the unit where it could be subject to:
    a. Heat sources such as radiators, heat registers, stoves or other products that produce heat
    b. Direct sunlight
    c. Mechanical vibration or shock
    d. Excessive dust
    e. Uneven surfaces

23. Do not leave the fan running unattended.

24. The fan must be fully and properly assembled before use.

25. The appliance is only intended for the purpose described in the user manual.

26. Do not use appliance or any part of the appliance out of the intended use to avoid risk.28. The use of attachments which are not recommended or sold by the appliance manufacturer may cause a risk of injury to persons.

27. Sufficient details for installation supplied.

OVERVIEW

1. Grille 5. Rear Grille
2. Fan Blade
3. Grille Ring
4. 4 x Rear Grille Locking Screw 8. Remote Control
5. DC Motor Housing
6. Power cord with plug
7. Remote Control

ASSEMBLING YOUR FAN

Assembling the Fan Body
If unsure, ask someone with experience to help you mount the fan.

Select an appropriate location (consider Power Cord length) and fix the Base onto a strong wall with the 4 provided ST5*32 Expansion Bolts, you will first need to drill holes in the wall that match the holes in the Base. If the power cord is hanging loose between the fan and the power outlet, make sure it cannot touch or obstruct fan blade rotation or fan oscillation at any time. (Figure 1 & Figure 2)

Assembling the Blade and Grille

1. Unscrew the 4 x Rear Grille Locking Screws M5*10 from the Motor Housing.

2. Align the Rear Grille on the Motor Housing, ensure that the grip is at the top. Then fix the rear grille in place using the 4 x Rear Grille Locking Screws (Figure 1).
   

3. Remove the protective sleeve on the motor shaft.

4. Loosen the Blade Screw, slide the Fan Blade onto the Motor Shaft as far as it will go. Replace the Blade Screw into the slot on the Motor Shaft and tighten clockwise. Ensure that the flat surface of the Motor Shaft is aligned with the Blade Screw. (Figure 2).
   

5. Loosen the screw at the grille ring. Place the security lock downwards, insert the front grille into corresponding position of the grille ring. Centre the Front Grille by aligning the central logo so that it is horizontal and parallel to the floor. Then tighten the screw of the security lock. **(Figure 3).

**

OPERATION

Remote Control
There is a “beep” sound on the control panel every time the remote control key is used.

1. OFF Button
2.  ON Button
3. Oscillates from side to side
4. Speed Button
5. Sleep Mode Button: Ultra low speed with gentle breeze effect and Lower noise level.
6. Natural Wind Mode Button: Fan speed varies automatically to simulate a breeze.
7. Timer Button

Note: Press timer button(7) to set the timer 1hr-2hr-4hr-8hr-12hr. The fan will turn off after set time. To Cancel the Timer , press and hold 12H for 3 secs until a ‘Beep ‘ is heard.

Pairing Multiple fans to One Handpiece.

Pairing One Additional Fan Method.
Check that the batteries are installed in the remote control, plug in the fan you want to take control of and within 10 seconds, press the “ON” button four times on the 4th press, hold the “ON” button until you hear a beep sound, indicating that the pairing procedure was successful. After it, press “ON” button to turn on the fan.

Pairing Multiple Fans Method.

After a fan is successfully paired, plug off the power of the paired fan. Repeat the “One Remote to One Fan

Pairing Method” for the next fan you want to pair.

Note: If you want to continue to pair multiple fans with the same remote control, please ensure that only one fan to be paired is plugged in. The same remote control can only be paired with a  maximum of 10 fans, andthe maximum remote control distance is 10m.

CARE AND MAINTENANCE

CAUTION

• Always switch off the fan before removing the grilles or performing any cleaning
• Do not use harsh detergents, chemical cleaners or solvents as they may damage the surface finish of the components.

1. Loosen the Grille Screw and open the Grille Clips to detach the Front Grille.
2. Use a soft duster or a rag to dust off all the surfaces.
3. Wipe all the parts with a soft damp (not wet) cloth dipped in mild soapy water . Caution: Ensure that water doesn’t get into the Motor Unit.
4. Use a dry cloth to thoroughly dry the blades and the grilles  beforereassembling

TECHNICAL SPECIFICATIONS

Rated Voltage: 220-240V~ 50Hz
Rated Power: 90W

STOAGE AND DISPOSAL

If you do not plan to use the fan for extended periods of time, it is recommended that it is cleaned and stored (preferably in its original packaging) in a cool, dry place.

Do not dispose of electrical products with household waste. Please check with your local council for advice on disposal or recycling. If electrical appliances are disposed of in landfills or dump s, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being

WARRANTY

OUR GOODS COME WITH GUARANTEES THAT CANNOT BE EXCLUDED UNDER THE AUSTRALIAN CONSUMER LAW. YOU ARE ENTITLED TO A REPLACEMENT OR REFUND FOR A MAJOR FAULT AND COMPENSATION FOR ANY OTHER REASONABLY FORESEEABLE LOSS OR DAMAGE. YOU ARE ALSO ENTITLED TO HAVE THE GOODS REPAIRED OR REPLACED IF THE GOODS FAIL TO BE OF ACCEPTABLE QUALITY AND THE FAILURE DOES NOT AMOUNT TO A MAJOR FAILURE.

This product is covered by a two years replacement warranty.

Before having the fan installed, check all the components to ensure there is no  Visual damage. Should there be any damage, return the fan to place of purchase for Replacement.

The following points need to be checked before requesting a warranty replacement. Please ensure your installer also reads this information

• The fan or relevant part has not been modified, subject to misuse, neglect or has been involved in an accident.
• The repairs are not required as a result of normal wear and tear.
• The product was installed in accordance with the instruction manual.
• No solid state speed control device has been used with this appliance.
• If you consider there are faults relating to the installation, contact your installer to Rectify. If you consider there is a manufacturer defect to the fan motor, contact the warranty Service line on 1300 665 926, or log the warranty at www.ventair.com.au/warranty

You will need to provide the following information:

• The name and contact details of the licensed electrical installer (if applicable)
• The brand, model number and colour of the unit.
• The date and place of purchase of the unit.
• The owners name, address and telephone contact numbers.
• The nature of the fault

4 CAPITAL PLACE
CARRUM DOWNS VIC 3201
PHONE: (03) 9775 0556
FAX: (03) 9775 0775

References

• Admin - Post Job

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>