CNC4PC C34G214V Function Boards User Manual
- June 9, 2024
- CNC4PC
Table of Contents
CNC4PC C34G214V Function Boards User Manual
OVERVIEW
This board interface is used for the connection between C35S, C62, C76, C82, M16D, C86MASSO, C86ACORN and GECKO DRIVE GR214.
FEATURES
- RJ45 Driver Input Connector
- Select Jumper for Hard Enable or Soft Enable.
- Alarm terminal
BOARD DESCRIPTION
JUMPER TO SELECT THE ENABLE
Use Software Enable to keep the driver active only while the system is active.
Set of jumpers as shown in the image.
SOFT ENABLE
Use Hardware Enable to keep the driver enabled all the time.
Set of jumpers as shown in the image.
HARD ENABLE
DRIVER RESET
When LOW, this input will reset the driver (phase outputs will disable).
WIRING SAMPLE
PINOUT
C34GR214 CONNECTOR RJ45
RJ45 Pins| Function
1| NOT USED
2| PUL+
3| NOT USED
4| GND
5| ERR
6| DIR+
7| NOT USED
8 (5V)| EN+
DIMENSION
All dimensions are in Millimeters.
DISCLAIMER
Use caution. CNC machines can be dangerous machines.
Neither DUNCAN USA, LLC nor Arturo Duncan is liable for any accidents
resulting from the improper use of these devices.
This product is not a fail-safe device and it should not be used in life
support systems or in other devices where its failure or possible erratic
operation could cause Board Description property damage, bodily injury or loss
of life.
References
- C35S - QUICK SETUP BREAKOUT BOARD
- C62 - Dual Port Multifunction Board
- C76 - UC300 Multifunction Board.
- C82 Ethernet Smooth Stepper Breakout board
- C86 Connector Board for the MASSO Controller
- POKEYS MOTION MOTHER BOARD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>