CNC4PC C48 -EXT_E-STOP and Probe Connector Board User Manual

June 9, 2024
CNC4PC

CNC4PC C48 -EXT_E-STOP and Probe Connector Board
CNC4PC C48 -EXT_E-STOP and Probe Connector Board

OVERVIEW

This board provides the interface to easily interconnect 1 Probe and 1 external E-Stop to CNC4PCbreakout board.

FEATURES

  • 1x 3.5mm jack connector for 1 Probe and Anti-Collision Feature New*
  • 1x 1/4″ jack connector for 1 External E-Stop (Secondary- Optional E-Stop)
  • RJ45 and Terminal for all I/Os and Power lines
  • Easily mountable in the panel of CNC Control Boxes

BOARD DESCRIPTION

BOARD DESCRIPTION
Requirements:
It requires a power supply of 5 to 24VDC@200mA to operate.

CONNECTOR RJ45

This connector allows an easy connection with C62, C76, or C82, boards. These RJ45 connectors are used not just to carry the INPUT/OUTPUT signals placed in terminals, but also to power board.

RJ45

DESCRIPTION| PIN
GND| 1
NOT USED| 2
EXT. E-STOP/EN| 3
PROBE| 4
INDEX| 5
EXT. E-STOP/EN| 6
5V/24V| 7
NOT USED| 8

PROBE JUMPER FOR RESISTOR

Set jumper in REQUIRED position if the input used in the breakout board to connect the probe signal is pulled to DOWN
PROBE JUMPER FOR RESISTOR

JUMPER EXTERNAL E-STOP

If an External E-STOP (Secondary) is connected set jumper in USED position, if not set jumper in position NOT USED
JUMPER EXTERNAL E-STOP

JUMPER E-STOP

If used a power supply of 5VDC, set the two jumper as sample in the image

If used a power supply of 24VDC and in the output of terminal de EN and EXTE STOP will work with 24V, set jumper as sample in the image.

TERMINALS

Signal of Enable
Signal internally wired to the EXT. E-STOP signal. It can be used as an external enable for a breakout board.

Signal EXT. E-STOP
This signal is the result of the series between E-STOP (Primary) and EXT. ESTOP(Secondary).

E-STOP (Primary)
An E-STOP must be connected to those terminals in order to get any E-STOP signal in the EXT. E-STOP terminal.

WIRING SAMPLE

Connection probe
WIRING SAMPLE

Collision Detection connection with probe
Collision Detection connection with probe

Collision Detection connection and external E-stop with probe
![Collision Detection connection and external E-stop with

probe](https://manuals.plus/wp-content/uploads/2023/03/Screenshot_14-201.png)

DIMENTIONS

DIMENTIONS

DISCLAIMER

Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC nor Arturo Duncan is liable for any accidents resulting from the improper use of these devices. This product is not a fail-safe device and it should not be used in life support systems or in other devices where its failure or possible erratic operation could cause property damage, bodily injury or loss of life.

CNC4PC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals