CNC4PC C34SST RJ45 Driver Board User Manual
- June 9, 2024
- CNC4PC
Table of Contents
USER’S
MANUAL VER. 1
C34SST-BOARD
Rev. 1
FEBRUARY 2022
OVERVIEW
This board interface is used for the connection between C82, C76, M16D, C62 C86MASSO, C86ACORN and the SST-ECLIPSE, Model E5xx
FEATURES
- DB25 MALE connector for Driver Connection.
- RJ45 Connector for Axis.
- Encoder Output.
- Select Jumper for Hard Enable or Soft Enable.
- Select Jumper active Low and active High
- Terminals for external drive enable push button.
BOARD DESCRIPTION
JUMPER TO SELECT THE ENABLE
Use Hardware Enable to keep the driver enabled all the time.
Set of jumpers as shown in the image.
Use Software Enable to keep the driver active only while the system is active. Set of jumpers as shown in the image.
4.1 Jumper alarm to select active low and active high.
WIRING SAMPLE
5.1 Diagram of connection with input signals and C76.
SSt- Eclipse , Model E 545
PINOUT
SSt-Eclipse E5xx SERIES SERVO DRIVE AND C34SST CONNECTION
DB25 MALE
PIN| FUNCTION| RJ45 PIN
20| + 5V| 8
21,7| COM- / GND| 4
15| ALARM *| 5
4| ENABLE| 5
8| DIR-F| 6
6| STEP+| 2
Note:
- Servo ON and Alarm signals are related to the RJ45 pin 5 of the C34SST board, but they are not connected directly to this pin.
RJ45 for Encoder
DB25 MALE PIN | RJ45 PIN | FUNCTION |
---|---|---|
23 | 3 | Z- |
11 | 4 | Z+ |
25 | 5 | A- |
13 | 6 | A+ |
24 | 7 | B- |
12 | 8 | B+ |
DIMENSION
All dimensions are in Millimeters.
DISCLAIMER
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC
nor Arturo Duncan is liable for any accidents resulting from the improper use
of these devices. This product is not a fail-safe device and it should not be
used in life support systems or in other devices where its failure or possible
erratic operation could cause property damage, bodily injury or loss of life.
References
- C62 - Dual Port Multifunction Board
- C76 - UC300 Multifunction Board.
- C82 Ethernet Smooth Stepper Breakout board
- C86 Connector Board for the MASSO Controller
- POKEYS MOTION MOTHER BOARD