VENTURE LIGHTING BF0008 LED Volumetric Troffer Fixture User Manual
- June 9, 2024
- VENTURE LIGHTING
Table of Contents
VENTURE LIGHTING’S LED VOLUMETRIC
TROFFER FIXTURE
STOP Before You Begin
Read These Instructions Completely and Carefully
Upgrade Instructions
STEP 1: Disconnect power from the existing luminaire and follow proper
lockout/tagout procedures before beginning installation or maintenance.
STEP 2: Remove the existing luminaire. Dispose of the lamp(s) and
ballast(s) per local requirements.
STEP 3: Bend the mounting tabs on each corner of the fixture out (approx.
90°). (A)
STEP 4: Place the fixture into a T-grid. (B)
STEP 5: Bend the tabs again so that the tab is flush against the T-grid
to ensure the mounting tab is securely hooked onto the T-grd. (C)
STEP 6: Use a #8 x 1/4” sheet metal screw to fasten the fixture to the
T-grid. (D)
STEP 7: Remove the wiring compartment cover plate. (E)
STEP 8: Make the necessary wiring connections as shown in the wiring
diagram. (F)
NOTE: The polarity of the dimming connections is important to ensure the
performance as desired.
NOTE: If not using the dimming functionality, DO NOT connect the Driver
Dim+ (purple) to the Driver DIM- (gray). The fixture will not operate as
desired.
STEP 9: Replace and secure the wiring compartment cover plate.
STEP 10: Power can now be restored to the fixture.
WARNING
Risk of fire and electric shock
- Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
- Venture Lighting’s LED Volumetric Troffer Fixture installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- The product should be installed and operated by a qualified electrician or technician in accordance with relevant local codes.
- Check to make sure that all fixture connections have been properly made and the fixture is grounded to avoid potential electrical shocks.
- Do not handle energized fixture when hands are wet, when standing on wet or damp surfaces, or in water.
- Suitable for use in damp and dry locations.
- Venture Lighting’s LED Volumentric Troffer Fixture is Type IC.
- The installer must determine that the supply voltage meets the fixture requirement.
http://www.venturelighting.com/
800-451-2606
6675 Parkland Blvd., Suite 100
Solon, OH 44139 USA
E-mail:[email protected]
VentureLighting.com
© 2022 Venture Lighting International • Venture Lighting is a registered
trademarks of Venture Lighting International.
Documents / Resources
|
VENTURE LIGHTING BF0008 LED Volumetric Troffer
Fixture
[pdf] User Manual
BF0008 LED Volumetric Troffer Fixture, BF0008, LED Volumetric Troffer Fixture,
Volumetric Troffer Fixture, Troffer Fixture, Fixture
---|---