i safe MOBILE M93A01 IS930.2 Tablet Set Android 20.3 cm User Manual

i safe MOBILE M93A01 IS930.2 Tablet Set Android 20.3 cm User Manual

This Operating Manual complies with these standards:
IEC 60079, IEC 82079, ANSI Z535.6
Diese Bedienungsanleitung erfüllt die Anforderungen der folgenden Normen:
IEC 60079, IEC 82079, ANSI Z535.6

DEVICE OVERVIEW/FUNCTIONS

Document No. 1041MM01REV02 Version: 2021-11-30
(c) 2021 i.safe MOBILE GmbH
i.safe MOBILE GmbH i_Park Tauberfranken 10 97922 Lauda-Koenigshofen
Germany
Tel. +49 9343/60148-0 info@isafe-mobile.com www.isafe-mobile.com
Template: TEMPMM01REV10

INTRODUCTION

This document contains information and safety regulations that are to be observed without fail for safe operation of the device IS930.2 (Model M93A01) under the described conditions. Non-observance of this information and instructions can have serious consequences and/or may violate regulations.
Please read the manual and these safety instructions before using the device. In case of contradicting information, the text of these safety instructions shall apply.
In case of any doubt, the German version shall apply.
The current EU declaration of conformity, Certificate of Conformity, safety instructions and manuals can be found at www.isafe-mobile.com or requested from i.safe MOBILE GmbH.

RESERVATION

The content of this document is presented as it currently exists. i.safe MOBILE GmbH does not provide any explicit or tacit guarantee for the accuracy or completeness of the content of this document, including, but not restricted to, the tacit guarantee of market suitability or fitness for a specific purpose unless applicable laws or court decisions make liability mandatory. i.safe MOBILE GmbH reserves the right to make changes to this document or to withdraw it any time without prior notice. Changes, errors and misprints may not be used as a basis for any claim for damages. All rights reserved. i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or indirect damages caused by any improper use of this device.

EX-SPECIFICATIONS

The device IS930.2 is suitable for use in potentially explosive atmospheres classified (zone 2/22) in accordance with directives 2014/34/EU, as well as the IECEx scheme.

EX-MARKINGS
ATEX: II 3G Ex ic
IIC T4 Gc IP64 II 3D Ex ic
IIIC T135°C Dc IP64
Certificate of Conformity : EPS 19 ATEX 1 072 X
CE-designation:
IECEx:
Ex ic IIC T4 Gc IP64 Ex ic
IIIC T135°C Dc IP64 IECEx
Certificate: IECEx EPS 19.0035X
North America: Class I Div 2 Groups A, B, C, D, T4
Class II Div 2 Groups F, G , T135°C
Class III Div 2 CSA20CA70220244
Temperature range: -20°C …+60°C (EN/IEC 60079-0)
-10°C …+55°C (EN/IEC 62368-1)
Manufactured by: i.safe
MOBILE GmbH i_Park Tauberfranken 10
97922 Lauda-Koenigshofen Germany

EU-DECLARATION OF CONFORMITY

The EU declaration of conformity can be found at the end of this manual.

FCC/IC STATEMENT

The FCC/IC Statement can be found under downloads on the product page of our website: www.isafe-obile.com/en/products.

FAULTS AND DAMAGES

If there is any reason to suspect that the safety of the device has been compromised, it must be withdrawn from use and removed from any ex-hazardous areas immediately. Measures must be taken to prevent any accidental restarting of the device. The safety of the device may be compromised, if for example:

• Malfunctions occur.
• The housing of the device shows damage.
• The device has been subjected to excessive loads.
• The device has been stored improperly.
• Markings or labels on the device are illegible.
• We recommend that a device displaying errors or in which an error is suspected be sent back to i.safe MOBILE GmbH to be checked.

EX-RELEVANT SAFETY REGULATIONS

Use of this device assumes that the operator observes the conventional safety regulations and has read and understood manual, safety instructions and certificate. The following safety regulations must also be complied with:

• Inside ex-hazardous areas the covers of all interfaces must be closed.
• To ensure the IP-protection, it has to be ensured that all gaskets are present and functional. There must be no large gap between the two halves of the housing.
• The device may only be charged outside ex-hazardous areas.
• Physical connections to equipment are only allowed outside ex-hazardous areas using equipment approved by i.safe MOBILE GmbH.
• The device may only be charged at ambient temperatures between +5°C … +35°C. The device may not be exposed to any aggressive acids or alkalis.
• The device may only be used in zones 2 or 22. Only accessories approved by i.safe MOBILE GmbH may be used.

EX-RELEVANT SAFETY REGULATIONS FOR NORTH AMERICA

Conditions of Acceptability:

• The battery may be charged outside explosion hazardous areas only using approved external adapter model ICP12-050-2000B with output rated 5Vdc, 2A or other external approved AC/DC adapter which also complies with the requirements of LPS and has output rated 5Vdc, 2A.
• Physical connections to other equipment are only allowed outside ex-hazardous areas.
• Opening of any interface or connector covers in an explosive atmosphere is not permitted.
• The product has been evaluated with rechargeable Li-ion battery pack model MBP93A01. The battery is not considered interchangeable.
• The device must be protected against excessive UV light emission and high electrostatic processes.
• The maximum rated operating temperature for charging is 35°C.

FURTHER SAFETY ADVISES

• Do not touch the screen of the device with sharp objects.
• Dust particles and nails may scratch the screen. Please maintain the screen clean. Remove dust on the screen with a soft cloth gently, and do not scratch the screen.
• Do not put the device in environments with excessive temperatures, as this could lead to heating of the battery, resulting in fire or explosion.
• Do not charge the device near any flammable or explosive substances. Charge the device under dry indoor conditions only.
• Do not charge the device in environments with much dust or humidity.
• Do not use the device in areas where regulations or legislation prohibit the use.
• Do not expose the device or charger to strong magnetic fields, such as are emitted from induction ovens or microwaves. Do not attempt to open or repair the device. Improper repair or opening can lead to the destruction of the device, fire or explosion.
• Only authorized personnel are allowed to repair the device.
• Only use accessories approved by i.safe MOBILE GmbH. Power off the device in hospitals or other places where the use of mobile phones is prohibited.
• This device may affect the proper work of medical equipment, such as pacemakers, so always keep a distance of at least 15 cm between the device and these devices.
• Observe all corresponding laws that are in force in the respective countries regarding the use of devices while operating a vehicle.
• Please power off the device and disconnect the charging cable before cleaning the device.
• Do not use any chemical cleaning agents to clean the device or the charger. Use a damp and anti-static soft cloth for cleaning.
• Do not discard old and abandoned lithium batteries into the trash, send them to designated waste disposal locations. The user alone is responsible for any and all damages and liabilities caused by malware downloaded when using the network or other data-exchange functions of the device. i.safe MOBILE GmbH cannot be held responsible for any of those claims.

WARNING
i.safe MOBILE GmbH will not assume any liability for damages caused by disregarding any of these advices or by any inappropriate use of the device.

MAINTENANCE/REPAIR

Please note any legal requirements for periodic inspection. The device itself has no user-serviceable parts. It is recommended to perform inspections according to the safety regulations and advice. If there is a problem with the device, please contact your vendor or consult the service center. If your device is in need of repair, you can either contact the service center or your vendor.

BATTERY

The battery is not fully charged when the device is purchased, but it contains enough energy to power on the device. To obtain the best battery performance and battery life, let the battery discharge completely before charging it completely for the first three charging cycles.
The device may only be charged at ambient temperatures in a range from +5°C … +35°C.

INSTALLATION OF THE MICRO SIM CARD

The device features a micro SIM card slot. The slot is accessible on the top of the device (see page 2).

WARNING  Do only change the SIM card when the device is switched off. Do not try to insert or remove the SIM cards when any external power supply is connected, otherwise, the SIM card may be damaged.

INSTALLATION OF THE microSD CARD

The device features a microSD card slot (up to 128GB). The slot for the microSD card is on the top of the device (see page 2). If you want to remove the microSD card, please make sure that the card is not in use by the device. To remove the microSD card follow the instructions given in  **< Settings>