BANDAI NAMCO DX Nichirin Sword User Manual

DX Nichirin Sword
User Manual

Content Description

Precaution

Parents and guardians: Please read this entire instructions sheet before allowing children to play.
Do not 1) hit anyone with toy, 2) poke anyone with toy, 3)swing toy at anyone, or 4) step on toy as it may result in serious injury.
Be careful not to pinch fingers with hinged parts of toy. Only use batteries of the same or equivalent type as indicated.
Batteries must be inserted with the correct polarity (see diagram). Do not short-circuit the supply terminals.
Do not mix different battery types or new and used batteries. Supervise children if they are replacing batteries themselves to ensure these mix are followed.
Caution: Keep batteries away from children. Batteries may be harmful if swallowed.
Distrubuted for Bandai America Incorporated, 2120 Park Place, Suite 120, El Segundo, CA 90245
Actual size, color, style and decoration may vary. Used under license by Bandai. Bandai Logo: ® and © 2020 Bandai.
All Rights Reserved. Package © 2020 Bandai.
Made in China

DEMON SLAYER: KIMETSU NO YAIBA – DX NICHIRIN SWORD PARTS

HOW TO INSTALL THE BATTERIES
INTO THE DEMON SLAYER: KIMETSU NO YAIBA – DX NICHIRIN SWORD
※Please set the power switch to the “X” (OFF) position before installing the batteries.
※Please replace all batteries with new batteries if the sound is difficult to hear, or if the sound exhibits any unusual behavior, such as repeats.

1. Remove the batter cover.
   Using small screwdriver, turn the screw counterclockwise, as shown in the diagram, to remove the battery cover from the main piece (hilt) as shown in ①－

2. Remove the batter cover as shown in ①－

3. Adult assembly required.

4. Insert the batteries.
   Insert the new batteries (2 x AAA batteries; sold separately) making sure that the + and – of the batteries are properly set. Adult assembly required.

5. Set the battery cover back into position.
   Place the battery cover back into its proper position on the main piece (hilt), then turn the screw clockwise (opposite of direction shown in ①－１) to secure the
   battery cover. Adult assembly required.

How To Turn On The Power
Move the power switch located on the bottom of the main piece (hilt) to the “O” (ON) position.
➡A sound effect will play when successful.
OFF
Power switch
Protrusion
ON
【Bottom view】
※Always set the power switch to the
“X” (OFF) position when you are done playing.
Please follow the warnings noted when setting the batteries.
※Please use brand new batteries. Do not use different battery types, battery brands, or battery labels together.
※Please set the batteries in the proper + and – position.
※Please turn the power off when you are done playing. Please remove the batteries if the product will not be used for an extensive period.
HOW TO USE THE DEMON SLAYER: KIMETSU NO YAIBA – DX NICHIRIN SWORD:  1 WATER BREATHING MODE

1. Insert the sword (Water Breathing) connector to the main piece (hilt) connector joint until you hear a click.
   ➡A sound effect will play when successful, and enable “Water Breathing Mode.

2. ① Press the button on the main piece (hilt).
   ➡With each button press, the Dialogue noted in the chart and corresponding sound effect will play.
   ② Hold the button on the main piece (hilt) for more than 1 second during a Dialogue playback.
   ➡A sound effect will play, and only the current Dialogue will play with each button press (loop state).
   ③ While (A) is playing, press the button again for more than 1 second.
   ➡A sound effect will play, and you will exit from the loop state.
   ※The word “Dialogue” refers to the entire string of sounds that play in the charts row.

※After Dialogue 10 plays, the Dialogue will loop back to Dialogue 1.
HOW TO REMOVE THE SWORD (WATER BREATHING)
To remove the sword (Water Breathing), pull in the direction shown in the diagram while the unlock buttons are held down.
➡A sound effect will play when successful, and enable “Action Mode” .

HOW TO USE THE DEMON SLAYER: KIMETSU NO YAIBA – DX NICHIRIN SWORD: 2 HINOKAMI KAGURA MODE

1. Insert the sword (Hinokami Kagura) connector to the main piece (hilt) connector joint until you hear a click.
   ➡A sound effect will play when successful, and enable “Hinokami Kagura Mode”.

2. Press the button on the main piece (hilt).
   ➡With each button press, the Dialogue noted in the chart and corresponding sound effect will play..

※After Dialogue 3 plays, the Dialogue will loop back to Dialogue 1.

HOW TO REMOVE THE SWORD (HINOKAMI KAGURA)

To remove the sword (Hinokami Kagura), pull in the direction shown in the diagram while the unlock buttons are held down.
➡A sound effect will play when successful, and enable “Action Mode” .

HOW TO USE THE DEMON SLAYER: KIMETSU NO YAIBA – DX NICHIRIN SWORD: ACTION MODE

1. Press the button on the main piece (hilt).
   You can skip the next Dialogue to play noted under (A) in the chart by pressing the button within 5 seconds after the current Dialogueʼ s playback. Note that when this is done during Dialogue 11, Dialogue 1 will play from “Mizu no Kokyu” (Water Breathing).
   ➡With each button press, the Dialogue noted in the chart and corresponding sound effect will play.

2. Swing the main piece (hilt) within 5 seconds from when the black colored section in the Dialogue chart finishes playing.
   ➡The corresponding sound effect will play.
   ※Position yourself while the black colored section in the Dialogue chart is playing.

3. Hold the button on the main piece (hilt) for more than 1 second during a Dialogue playback.
   ➡A sound effect will play, and only the current Dialogue will play with each button press (loop state)..

4. While (A) is playing, press the button again for more than 1 second..
   ➡A sound effect will play, and you will exit from the loop state.
   ※The word “Dialogue” refers to the entire string of sounds that play in the chartʼ s row.

3 ACTION MODE (English Translation)

※For Dialogue 3, 9, and 10, you can play SFX2 for each swing done within 5 seconds after the initial SFX2 plays.
※For Dialogue 11, each swing will play the SFX sequentially in order of SFX1, SFX2, then SFX3.
※After Dialogue 11, the next Dialogue 1 will play from “Mizu no Kokyu” (Water Breathing)..

©Koyoharu Gotoge / SHUEISHA, Aniplex, ufotable

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>