smartwares SH4-90268 Wireless Plug-in Power Switch Instruction Manual
- June 9, 2024
- smartwares
Table of Contents
smartwares SH4-90268 Wireless Plug-in Power Switch
INSTALLING THE RECEIVER
- Insert the receiver into the wall outlet.
Pairing the receiver with a sender
-
A. Press and hold the button on the receiver for 3 seconds, then release it. The LED starts to blink. Your receiver is now switched to pairing mode.
Attention: the LED should only blink after releasing the button. If the LED starts to blink while holding the button, there will be no pairing. -
B. Press the on button on the sender (see the instructions given in the manual for the sender).
-
C. The LED on the receiver will light up.
-
D. Your receiver and sender are now paired.
Preparing the receiver
- Connect a desired device to the receiver and make sure the desired device is switched on. Now, the receiver is ready for use.
DISCONNETING ALL LINKS
- A. Press and hold the button on the receiver for 10 seconds until the LED starts to blink.
- B. When the LED on the receiver turns off, all links will be disconnected.
Specifications
- Maximum power: 2300W
- Frequency: 433.92MHz
- Maximum RF output: 0dBm
- AC input: 230V ~ 50Hz
- Maximum range: 30 m
Smartwares Europe
Jules Verneweg 87 5015 BH Tilburg
The Netherlands
Email: www.smartwares.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>