Lorelli Twinkle Electric Baby Swing Rhino Instruction Manual

June 4, 2024
lorelli

Lorelli Twinkle Electric Baby Swing Rhino

Lorelli-Twinkle-Electric-Baby-Swing-Rhino-PRODUCT

SAFETY REQUIREMENTS

  1.   WARNING! This product is suitable for use by babies ranging from O+ months old with a maximal weight of 9 kg.
  2.   WARNING! Never leave the child unattended.
  3.   WARNING! Do not use this product once your child can sit up unaided or weighs more than 9 kg.
  4.   WARNING! This product is not intended for prolonged periods of sleeping.
  5.   WARNING! Never use this product on an elevated surface (e.g. a table).
  6.   WARNING! Always use the restraint system.
  7.   WARNING! To avoid injury ensure that children are kept away when unfolding and folding this product.
  8.   WARNING! Do not let children play with this product.
  9. . WARNING! Do not move or lift this product with the baby inside it.
  10.   WARNING! Toy bar is an additional article! Keep removed toy bar on a safety place! Never use the toy bar to carry the product!
  11.   WARNING! Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces.
  12.   WARNING! This article does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
  13.   WARNING! For domestic use only!
  14.   WARNING! Regularly check for loose parts! Make routine inspection, regularly maintain, clean and/or wash the article!
  15.   WARNING ! Do not use this product if any components are broken or missing!
  16.   WARNING! When the product is connected to a music player, ensure that the volume of the music player is set to a low value.
    • CAUTION: This package contains small parts in its unassembled state!
    • On adjusting the backrest you must be sure that the mechanism is well locked in the chosen position.
    • Use the upright position only when child has developed enough upper body control to sit without leaning forward.
    • Do not leave the article near a switched on fan, heat sources, sharp objects and water containers. Do not use accessories or replacement parts other than those
    • approved by the manufacturer. Adult assembly is required.
      Product features and decorations may vary from photographs.

PARTS

  1.  Right leg – 1 pcs.
  2.  Left leg – 1 pcs.
  3.  Toy bar – 1 pcs
  4.  Seat – 1 pcs.
  5. Base supports – 2pcs.
  6. Adapter – 1 pcs.
  7.  Remote control – 1pcs.

ASSEMBLING

N.B.:The product must be assembled by an adult!

  1. Open the left leg and right leg (1 and 2) and assemble them to the base supports 5 until you hear a click as shown on photo 2. Lorelli-Twinkle-Electric-Baby-Swing-Rhino-FIG-2Attention: Ensure that the mechanism is locked and you can use the rocker safely by pulling both legs to the base supports.
  2.  Assemble the seat 4 to both legs by keeping the correct numbering and the relevant D-shape of the locking mechanism-photo3.Lorelli-Twinkle-Electric-Baby-Swing-Rhino-FIG-3
  3.  Put the cover and unfold the back rest to the required position-photo 4.
  4. Adjust well the length of the shoulder belts as shown on photo 5.Lorelli-Twinkle-Electric-Baby-Swing-Rhino-FIG-4
  5.  Put the toy bar as shown on photo 6 and adjust it to the desired position.

DISASSEMBLY

  1. Disassemble the toy bar by holding it from both sides and pulling it upwards photo 7.Lorelli-Twinkle-Electric-Baby-Swing-Rhino-FIG-5
  2. Disassemble the seat by using hard and thin metal object to push the quick release buttons down and to the end and simultaneously pull the seat’s arm outwards from its both sides – photo 8.
  3.  Disassemble the two legs by using small hard object to press the metal parts in the base and then pull the legs upwards photo 9Lorelli-Twinkle-Electric-Baby-Swing-Rhino-FIG-6

POWER SUPPLY

  1. Connect the adapter jack (6) to the powerjack of the right leg-photo 10. Plug in the adapter to the grid. AC 100-240 V 50/60 Hz 0.3A Max
    ATTENTION!!! For your safety, please use the original power adapter.
    Input voltage: AC 100-240V 50/60 Hz 0.3A Max/ Output voltage: DC5.8V 1A. (The manufacturer waives liability for any lossesS
    caused by the use of power adapter other than the designated one.) Do not use the power adapter if it is damaged. Do not touch
    the plug of the power adapter with conductors, for example rings. Prevent the child from playing with the adapter or the batteries!
    Keep the adapter away trom the child when plugged!
    Converters used for the baby rocker must be regularly checked for damages of the cable, the plug, the body and other parts and
    must not be used if damaged! The baby rocker must be used only with the recommended converter.

  2.  Batteries-this product uses 4 batteries type AAA 1.5V (not included in the set).

    • Unscrew and open the cover of the batteries department-photo 11.
    • Batteries must be placed according to their polarity”* and
    • Battery replacement-tip: We recommend the use of alkaline batteries for longer operation.
    • Putback the cover of the battery compartment and tighten the screws with a screwdriver. Do nottighten too much.
    • If the product operates incorrectiy it may be necessary to reset the electronics.
    • Remove the batteries and then place them again.
    • Batteries must be replaced by an adult when the sound is down or stops!

BATTERIES SAFETY INFORMATION

  • WARNING! In some special condition, from the battery may leak the liquid, which may cause a chemical burn or damage the product. 1o avoId batterys leakage
    • Do not mix old and new batteries or different types of batteries like alkaline, standard (carbon- zinc ) or rechargeable batteries (Ni-Cr)
    •  Please insert the batteries as indicated inside of the battery compartment.
    •  If you don’t use this product for a long time, please remove the batteries. Exhausted batteries are to be removed from the infant swing. Please carefully, dispose the waste batteries. Do not dispose the batteries in to the fire. Ihe battery may explode or leak.
  • Do not cause short circuit of the batteries terminal.
    •  Use only the same batteries or batteries from one type as is required.
    • Do not recharge non rechargeable batteries.
    • Take out the batteries from the product before recharging.
    • If you use rechargeable batteries, the charging should be under adult control.

FUNCTIONS

Description of light indicators.

  1.  Light indicator ONN

  2.  Light indicator for speed of swinging

  3.  Remote control sensor

  4.  Light indicator for sound

  5.  Light indicator for time

  6. Mp3 function-photo 13

    •  Connect USB stick to USB socket, press the tune button to play the music from the USB stick.
    •  Remove the USB stick to play the tunes built in the rocker.
  7.   Bluetooth function-photo 14
    Switch on the bluetooth function and find Bt3403, the rocker wil start playing the music from the phone.

  8. Folding function-photo 15
    Press the two buttons for folding located on both sides of legs, slightly lift the product and it will fold on its own.

  9. Back rest adjustment-photo 16

    • Press simultaneously the back rest adjustment buttons on the left and the right side to regulate the back rest position.
  10. Locking and unlocking function-photo 17

    •  Press the locking button located underneath to fix the position of the rocker. To release the rocker to move, press the button in the reverse direction. Attention: The SWINGING function must be stopped before using the locking and unlocking function.

USING THE BELTS

Attention: Always use the safety system! Put the child on the seat. Put the pad of the belt between the child’s legs. Fasten the waist belt on each side of the pad. Fasten each belt so that it holds firmly the child. Please be sure that you hear the click. Check whether the belt is well fastened by pulling it. Adjust the belt length: Adjust the abdominal belts by pressing the button and by sliding the buckle and the shoulder belts by sliding the buckle.

CLEANING AND CARE

Remove the cover of the rocker after folding the seat to the back rest and releasing the safety belts on the pack (photo 18).

  1. Wash the cover with cool water and soft soap. Dry it naturally. Do not bleach. Remove the sturdy stains with non-abrasive cleaning cream.
  2.  Clean the frame, the toy bar and the toys with wet cloth and mild detergent. Do not use strong and abrasive agents. Rinse with clean water to remove the remaining detergents. Do not soak the frame or the toys in water.

STORAGE

  1. Remove the batteriea and store them away from children.

Tel.: +359 54 850 830
e-mail: home.market@didis-ltd.com
e-mail: export@didis-ltd.com

Please select text to grab.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals