STEGO ETF 012 Hygrotherm with External Sensor User Guide

June 4, 2024
STEGO

Quick Start Guide

ETF 012 Hygrotherm with External Sensor

Type ETF 012
Store for use at a later date.

WARNING
**** There is a risk of personal injury and equipment damage if the connection values are not observed or polarity is incorrect!

Type 1 Action

| 2K ± 1K
4%rF ± 1%rF| | 0.5Nm max.
(4.4lb-in)
---|---|---|---
| AC100-240V, 50/60Hz,
DC24V-48V, 1W| | -0 … +60°C
(32 … +140°F)
| max. 90%rH| | 0.2kg

USAGE

The electronic temperature and humidity regulators are used to switch heaters, cooling equipment, filter fans or signal devices on or off if the temperature or humidity value rises above or falls below an adjustable or preset reference value. The controllers must only be used in stationary, sealed housings for electrical devices. There is a default response delay of approximately 5 sec. The external sensor with cable can detect the temperature decentrally (observe temperature range!).

Versions

  • Internal temperature and humidity sensor
  • External temperature and humidity sensor

Safety considerations

  • Installation must only be performed by qualified electrical technicians in observation of the respective national power-supply guidelines (IEC 60364).
  • The safety measures according to VDE 0100 are to be ensured.
  • The technical specifications on the type plate must be strictly observed!
  • No changes or modifications must be made to the device.
  • In case of apparent damage or malfunction, the device may not be repaired or put into operation. (Dispose of device.)

Installation guidelines

  • The regulator should be installed in the upper area of the electric cabinet as far as possible from heaters or other heat-generating
    components.

  • Alternatively, the external sensor enables the detection of heat/humidity far from the regulator.

  • The device must not be covered.

  • The device must not be operated in environments with aggressive atmospheres.

  • The device is to be installed vertically, i.e. with the connection terminals at the bottom.

  • Mode of operation: 1.C

  • Degree of contamination: 2

  • Rated impulse voltage: 4kV

Humidity function
If the relative humidity exceeds the value set on the humidity dial, the electric circuit is closed via terminals 5-3. LED illuminates.

Temperature function

If the ambient temperature drops below the value set on the temperature dial, the electric circuit is closed via terminals 5-3. LED illuminates. If the ambient temperature rises above the value set on the temperature dial, the electric circuit is opened via terminals 5-3.
Notice
The manufacturer accepts no liability in the case of failure to observe this brief instruction, improper use, and changes or damage to the device.

STEGO Elektrotechnik GmbH – Kolpingstrasse 21 – 74523 Schwaebisch Hall Germany – www.stego.de

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals