STEGO KFR 012 Mechanical Hygrostat User Manual
- June 4, 2024
- STEGO
Table of Contents
STEGO KFR 012 Mechanical Hygrostat
SPECIFICATIONS
 |
4%rF ± 3%rF |
|---|---|
 |
min. AC/DC |
20V, 100mA
max. AC 250V, 5A; DC 20W
| max. 95%rH
| 0.5Nm max. (4
.4lb-in)
| 0 … +60°C (32
… +140°F)
| MFR 012: 60g
KFR 012: 40g
Store for use at a later date.
USAGE
The mechanical humidity regulators are used to switch heaters, cooling equipment, filter fans or signal devices on or off if the temperature or humidity value rises above or falls below an adjustable or preset reference value. The regulators must only be used in stationary, sealed housings for electrical devices.
CONNECTIONS
Safety considerations
- Installation must only be performed by qualified electrical technicians in observation of the respective national power-supply guidelines (IEC 60364).
- The safety measures according to VDE 0100 are to be ensured.
- The technical specifications on the type plate must be strictly observed!
- No changes or modifications must be made to the device.
- In case of apparent damage or malfunction, the device may not be repaired or put into operation. (Dispose of device.)
Installation guidelines
- The regulator should be mounted in the lower third of the switch cabinet.
- The device must not be covered.
- The device must not be operated in environments with aggressive atmospheres.
Notice
The manufacturer accepts no liability in the case of failure to observe this
brief instruction, improper use and changes or damage to the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>