STEGO HVL 031 Industrial Fan Heater User Manual
- June 4, 2024
- STEGO
Table of Contents
STEGO HVL 031 Industrial Fan Heater
OVERVIEW
FEATURES
-
HV/HVL – 230V/120V
-
100W – 1A/1.4A
-
150W – 1.25A/2A
-
200W – 1.4A/2.5A
-
HV/HVL – 230V/120V
-
300W – 2A/4A
-
400W – 4A/5A
-
35m³/h (HVL 100-150W)
-
108m³/h (HVL 200-400W)
-
AC 230V, 50/60Hz
-
AC 120V, 50/60Hz
-
DC 24V
-
max. 90%rH
-
VDE: 0.8Nm (7.1lb-in)
-
UL: 0.5Nm (4.5 lb-in)
-
-45 … +70°C
-
(49 … +158°F)
-
0.4kg (HV 100-150W)
-
0.5kg (HV 200-400W)
-
0.6kg (HVL 100-150W)
-
0.9kg (HVL 200-400W)
CIRCUIT
WARNING
- There is a risk of personal injury and equipment damage if the connection values are not observed or polarity is incorrect!
- Hot surfaces following commissioning! Risk of injury!
USAGE
Heating units are used to prevent the development of condensation and drops in temperature in control cabinets. The heaters must only be used in stationary, sealed housings for electrical devices. Heating units without an integrated thermostat should be connected in series to a suitable thermostat for temperature control. Heating units must not be used for the heating of rooms.
Safety considerations
- Installation must only be performed by qualified electrical technicians in observation of the respective national power-supply guidelines (IEC 60364).
- The safety measures according to VDE 0100 are to be ensured.
- The technical specifications on the type plate must be strictly observed!
- The user of the heater must ensure through an installation that components that are mounted above the air outlet grating are not damaged by the hot outlet air.
- The device must be connected to the mains via an all-pole disconnecting device (with a contact gap of at least 3 mm in the switched-off state).
- The device must not be operated in environments with aggressive atmospheres.
- The device is installed horizontally (air blow direction upwards).
- The device must only be operated in an environment that ensures contamination class 2 (or better) in accordance with IEC 61010. Contamination class 2 means that only non-conductive contamination may occur. However, it is likely that there will occasionally be temporary conductivity caused by condensation.
- No changes or modifications must be made to the device.
- In the event of any damage to or malfunction of the heating unit, the device must not be repaired or put into operation (dispose of the heating unit).
- Dismantle the heater only after it has cooled down.
Attention
- The heater must not be mounted on flammable materials (e.g. wood, plastic, etc.).
- The heater must always be operated together with the fan! DANGER OF OVERHEATING!
Notice: The manufacturer accepts no liability in the case of failure to observe this brief instruction, improper use, and changes or damage to the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>