STEGO CR 027 FAN Heater User Guide
- June 4, 2024
- STEGO
Table of Contents
Quick Start Guide
| 6.3A (T) (02700.0-00)
8A (T) (02701.0-00, 02700.9-00, 02701.9-00)
---|---
| 35m³/h (02700.x-xx)
45m³/h (02701.x-xx)
| AC 220-240V, 50/60Hz
AC 100-120V, 50/60Hz
| max. 90%rH
| 0.8Nm
(7.1lb-in)
| -45 … +70°C
(-49 … +158°F)
| 0.9kg (02700.x-xx)
1.1kg (02701.xx-xx)
| WARNING
---|---
There is a risk of personal injury and equipment damage if the connection
values are not observed or polarity is incorrect!
**| WARNING**
Hot surfaces following commissioning! Risk of injury!
USAGE
Heating units are used to prevent the development of condensation and drops in temperature in control cabinets. The heaters must only be used in stationary, sealed housings for electrical devices. Heating units without an integrated thermostat should be connected in series to a suitable thermostat for temperature control. Heating units must not be used for the heating of rooms.
Safety considerations
- Installation must only be performed by qualified electrical technicians in observation of the respective national power-supply guidelines (IEC 60364).
- The safety measures according to VDE 0100 are to be ensured.
- The technical specifications on the type plate must be strictly observed!
- The user of the heater must ensure through an installation that components that are mounted above the air outlet grating are not damaged by the hot outlet air.
- The device must be connected to the mains via an all-pole disconnecting device (with a contact gap of at least 3 mm in the switched-off state).
- The device must not be operated in environments with aggressive atmospheres.
- The device is to be installed vertically (air blow direction upwards).
- No changes or modifications must be made to the device.
- In the event of any damage to or malfunction of the heating unit, the device must not be repaired or put into operation (dispose of the heating unit).
- Dismantle the heater only after it has cooled down.
Attention! The heater must not be mounted on flammable materials (e.g.
wood, plastic, etc.).
Attention! The heater must always be operated together with the fan!
DANGER OF OVERHEATING!
Notice
The manufacturer accepts no liability in the case of failure to observe this
brief instruction, improper use, and changes or damage to the device.
Type CR 027
Zum späteren Gebrauch aufbewahren.
Store for use at a later date.
STEGO Elektrotechnik GmbH – Kolpingstrasse 21 – 74523 Schwaebisch Hall
Germany
www.stego.de
681138
12/2021 – d
Documents / Resources
|
STEGO CR 027 FAN
Heater
[pdf] User Guide
CR 027, FAN Heater, CR 027 FAN Heater, Heater
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>