sylvan S785 Mortice Lock Instruction Manual
- June 9, 2024
- sylvan
Table of Contents
sylvan S785 Mortice Lock
Please note: The latch bolt on these locks may be reversed without opening the case. To reverse, insert a screwdriver through the back of the case and push the latch bolt out away from the lock face, while pushing turn the screwdriver 180 degrees until the latch bolt realigns and engages with the lock face.
INSTALLATION INSTRUCTIONS
- Use drilling template (see reverse) or hold the lock at the required position.
- Draw horizontal lines on the door edge marking the top and bottom of the lock body.
- Mark a vertical line at the centre of the door edge between the two horizontal lines.
- Using the attached drilling template and a 16mm bit, drill a series of holes (A) along this line to the depth of the lock body (B) or (C) or (D) or (E) depending on depth of lock body.
- The remainder of the hole should now be chiselled out to accept the lock body.
- *allow an extra 5-10mm extra depth/height for the mortice rebate
- Insert the lock and mark around the forend.
- Chisel out this area to the full depth of the forend.
- Use drilling template (see reverse) or hold the lock against the door and mark the positions for spindle and keyhole (F) or (G) or (H) or (I) depending on backset.
- Prepare the hole. Fit the lock and cylinder and ensure that the bolt works correctly. Screw the lock into position.
- On the door frame, mark the top of the roller bolt or latchbolt and the bottom of the deadbolt.
- Using these guidelines check out and fit the striker plate.
- Ensure tongue of striker plate is around the correct way, depending on the handing of the door.
Residential Door Hardware Warranty
Sylvan residential door hardware products are covered by the following warranty.
- 10 year mechanical.
- 5 year finish (see exclusions below).
- Subject to the following conditions:
- If a finish or mechanical defect occurs within the warranty period, simply return the product together with proof of purchase to the point of purchase. Upon receipt of the defective product, it will be either repaired or replaced free of charge. This warranty only applies to the original user of the product and is non-transferable.
- The Sylvan residential door hardware warranty excludes the following:
- Indirect or consequential loss or damage
- Cost of removal and or replacement
- Cost of freight and or travel time
- Improper installation or failure to follow fitting instructions
- Abuse or misuse of the product
- Use of the product for the purpose which the product was not designed
- Scratches from keys/rings, abrasions or deterioration due to use of paint, solvents or other chemicals
- Use of the product in exposed coastal or geothermal conditions
- The plated finishes of Polish Brass and
- Black Nickel are classified as soft finish. As deterioration is possible under some climatic conditions, these finishes are excluded from this warranty.
DIMENSION
NOTE: Choose the correct fold line for your lock body depth
Note: If reprinting this template, ensure you print 1:1 ratio, and double-check the drilling template with an accurate ruler.
P: +64 9 444 5359 F: +64 9 444 3972 sales@gdrutter.co.nz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>