sylvan E64 Dummy Trim Lever Handle Satin Nickel Plate Installation Guide
- June 9, 2024
- sylvan
Table of Contents
sylvan E64 Dummy Trim Lever Handle Satin Nickel Plate
Mark and drill door
Start approx 990mm from the floor, fold and apply the supplied template and
mark 2 centre points at your desired backset of 60mm or 70mm. Using a 2.5mm
drill bit, drill to a depth of 5mm using the marked holes. Remove the Lever
from base.
Using the pin supplied, press the anchor point and remove the lever from the
base. Remove the Rose from base.
Using the supplied install driver, depress the rose anchor point and pull the
rose to remove from the base.
Install the Lever
Place the rose on the door aligning the holes with the pre-drilled holes and
insert x2 supplied screws, install the rose firmly placing over the base until
set. The install the Lever by placing over the base and slide on until it
clicks. With this fixed dummy set we recommend using our MC1 Magnet, visit our
website for further information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>