HDMI E5 32GB Set Top Box User Manual
- June 9, 2024
- HDMI
Table of Contents
HDMI E5 32GB Set Top Box
Package Contents
Connection
AV Connection
- A. Connect the AV cable of the 3 color (red/ white/yellow) to the E5’s AV output interface, and the other end to the TV’s AV input interface. Connection can be made by colour.
- B. Power on the E5. Set the TV video mode to AV input.
HDTV Connection
- A. Connect HDMI cable to the E5’s output interface, and the other end to the TV’s HDMI input interface.
- B. Power on the E5. Set the TV video mode to HDTV input.
Installation Steps
- Connect E5 Set top box TV Box to the power supply.
- Connect E5 to your TV with an HDMI Cable or AV Cable.
- For a wired connection, plug-in an Ethernet cable from the TV Box to your modem or router. For wireless, choose your Wi-Fi network and input your Wi-Fi password.
- LED Light: Blue ON Red OFF Green INTERNET CONNECTION
Troubleshooting
Warning: Under no circumstances should you try to repair the E5 unit by
yourself, as this will invalidate the warranty. Do not open it as there is a
risk electrical shock. If any fault occurs, please first check with this
troubleshooting checklist. If you are unable to remedy a problem by following
this guide, contact your dealer for help.
IR-200 Remote
Learning Function
The learning function on the IR-200 remote is used to control your TV. You will be able to control: Power ON/OFF, Volume and Input Source. To do this you will need the factory remote control for your TV.
- Press the learning key you would like to program (TV POWER/ SOURCE/ VOL+/ VOL-) and the red light will start flashing. The flashing red light indicates the IR-200 is in learning mode.
- Align your TV Remote and the IR-200 so that the front transmitters are pointing at each other. They should be within 1 inch or 3 cm of each other.
- After receiving a learning function successfully, the red light will blink 4 times.
- To learn other keys, repeat Steps 2-4
- After learning, long press the OK key for 3 seconds, and the red light will blink twice to save learning
Note:
If you do not select the key within 15 seconds after entering the learning
state, it will automatically exit the learning state.
Please note not all TVs are compatible with source pairing
CEC settings to support the IR-200, your TV & the E5 If you were successful in
TV source pairing the IR-200 to your TV then you need to make sure the CEC
settings on both the TV and the E5 are enabled and in some cases in the
correct HDMI port on the TV, refer to your TV manual if needed. (The E5 is
initially set to ON)
Warranty Information
For warranty information and registration, please visit:
www.buzztv.com/register
www.buzztv.com/support
Csobuzztv.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>