Luminans JP-9110-12 – Kevin LED Lighting without Compromise Instruction Manual
- June 9, 2024
- Luminans
Table of Contents
Luminans JP-9110-12 – Kevin LED Lighting without Compromise
WHAT IN THE BOX
DIMENSION
Symbols
Conforms to EU directives for safety, EMC and environment.
Intended both for indoor and outdoor use (NOT DRIVER).
LED light source.
Ingress protection for luminaire.
Ingress protection of driver and connections.
Protection class, class II, double insulated.
Indicates the adjustability of the luminaire.
LED Operating current.
Luminaire can be installed directly in isolation.
Dimmable. Compatible with most 230 VAC dimmers.
WEEE – Waste of electrical and electronic equipment.
Conforms with the RoHS directive (Restriction of Hazardous Substances).
Cut-Out.
Beam Angle.
Non-replaceable light source.
Replaceable control gear by an end-user.
Product Information and Manufacture Declaration:
www.luminans.com
SAFETY AND INSTALLATION INSTRUCTIONS
Read these instructions carefully before commencing installation and retain for future reference. The luminaire should be installed by a licensed electrician and in accordance with local regulations. Make sure that the power is off before installation or maintenance. Install as described below. Place the LED luminaires and the converter far away from heat sources and in a well- ventilated area. Use the supplied cable and driver for best function and safety.
Recommended is a multi thread leader 1,5mm² for the remaining installation.
NOTE: The light source in this luminaire may only be replaced by the manufacturer or by qualified personnel designated by the manufacturer.
Never regulate the power on the secondary side, this can damage or destroy the
LED.
Faulty installation may void warranty. When installing in wet areas, the
driver must be placed in a dry zone.
JP International Technologies AB, Runstensvägen 5, 175 61 Järfälla, Sweden. I www.luminans.com I rev4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>