vetus ILT120B/X/F Inspection Lid for Rigid Tanks Instruction Manual
- June 9, 2024
- vetus
Table of Contents
vetus ILT120B/X/F Inspection Lid for Rigid Tanks
Installation manual Inspection lid for rigid tanks
ILT120B / ILT120X / ILT120F
Introduction
This manual is applicable to the installation of the inspection lid for rigid tanks. The tank may be made from plastic, GRP or metal and should have a mini- mum wall thickness of 0.8 mm.
NOTE!
Consult the manual supplied with the tank for instructions on how to
connect it.
Installation
Cutting the hole for the inspection lid
- Position the inspection lid on the top face of the tank. If a VETUS tank is used, then it should be fitted with plug P on the top and the inspection lid should preferably be located so that plug P is removed when the hole is cut.
- Cut the hole in the tank and remove all burrs. Preferably use a holesaw (159 mm, 6 1/4” diam.).
- Clean the inside of the tanks before fitting the inspection lid.
Rubber seal to be applied Determine the thickness of the wall of the tank and use the indicated rubber seal.
Installation of connector lid
Flange (1)
- Position the flange (1) into the hole of the tank.
- Tighten each of the 4 screws (2) one (-1-) revo-lution (clockwise) and check if the flange can be rotated easily by hand. Repeat this until the flange can’t be rotated anymore.
- Now all screws have to be tightened four (-4-) turns. Do this by, one after the other, tightening each screw one (-1-) revolution. Repeat this ac-tion three (-3-) times.
Ground connection (3)
- Use the screw to connect the flange to ground.
Lid (4)
- Screw the lid onto the flange.
NOTE!
Check the tightness of all connections before filling the tank.
ILT120B and ILT120X not suitable for water containing chlorine. For water
containing chlorine, use an ILT120F
**Description
**
The blind plate of the inspection cover can be replaced by one of the different connec-tion kits. These connection kits have the ne-cessary connections for respectively a tank for fuel (ILTCONF38), drinking water (ILT- COND) or waste water (ILTCONW).
TEL.: +31 (0)88 4884700 – sales@vetus.nl – www.vetus.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>