AQUALUX Aqua 4 4-Fold 840mm x 1400mm Bath Screen Instruction Manual

AQUALUX Aqua 4 4-Fold 840mm x 1400mm Bath Screen

Before You Start:

• Check that the bath has been installed correctly and that it is level. Please Note: All product supplied without bath.
• Check that there is sufficient space on the bath for the product and that the screen movement does not impact on other items such as sinks and taps.
• Ensure the product is fitted to a non-porous surface ie. tiled. Check that the wall surface is flat.
• Unpack and check the product is complete and undamaged, (refer to ‘Parts & Fittings Supplied’ and ‘Loose Screws & Fittings Supplied’ sections for details.
•  Fixings are supplied for solid walls only. Ensure that the correct fixings are used for the wall type – if in doubt seek professional advice.
•  Ensure the area is clean, dry and dust free.
•  Read the instructions in full.
• Have the correct tools available, (as shown below, see ‘Tools Required’).

Safety:

•  Handle all glass with care – support on cardboard to avoid risk of breakage.
• This product is heavy and requires 2 people to carry and install it.
• Check walls first for hidden pipes and cables before drilling.
• All glass is toughened – it cannot be reworked or replaced by ordinary glass.
• Use safety eyewear when drilling.
• Use safety eyewear when handling glass.
• Keep all small parts away from children.

Disclaimer:

•  Please notify the retailer immediately of any damage or faults. The manufacturer cannot be held responsible for any installation costs that may arise from damaged or faulty product being installed.
• Please dispose of all packaging with due regard to the environment.

Tools Required (not supplied)

Parts & Fittings Supplied

Keep small parts away from children

Loose Screws & Fittings Supplied

Tip:

• When drilling tiles apply masking tape to surface to stop drill bit slipping.
• Wall plugs supplied are for solid walls only. Ensure correct wall plug for wall type is used. If in doubt seek professional advice.
• Position wall channel on wall. Ensure channel is vertically level and does not overhang the bath.

Please Note:

• Position Wall Channel with curved side facing away from bath.

Horizontal Seal Preparation:

• Tip:
  Apply a small amount of Silicone Lubricant to the Horizontal Seal to help slide into position.

Underside View:

• Apply a small amount of silicone sealant to End Cap and Seal End Caps.
• Push fit End Cap and Seal End Caps.
• Trim Horizontal Seal overlap.

Please Note:
Ensure Horizontal Seal sits on top of bath.

• Push fit Hinge Screw Cover Caps.

• Apply a small amount of Silicone Grease from sachet (supplied) to the hinge mouldings.

• Apply Silicone Sealant, (not supplied).

Product Care: Use a non abrasive cleaner. Water marks may be removed with a proprietary limescale remover or household vinegar.
Apply Silicone (not supplied).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>