easee Charging Robot Instruction Manual
- June 9, 2024
- easee
Table of Contents
easee Charging Robot
INRODUCTION
The information in this leaflet apply to Easee Charge, Easee Home and Easee
One, unless specified otherwise. Keep this information for future reference.
Read this information carefully before installing and operating the product.
The Installation guide and User guide are an integral part of the product
documentation. All information is available online at easee.com/manuals.
Installation and operation of the product require a mobile device with
internet connection.
Intended use
This product is intended solely for charging electrically powered vehicles
equipped with non-gassing batteries.
Uses other than those specified here are not permitted.
Operating conditions
The product shall only be used with a charging cable according to IEC 62196. The product must be firmly mounted on a vertical unperforated wall or structure that covers the entire back side of the product and has a sufficient load-bearing capacity. It may only be operated within the approved operating parameters (see Technical specifications in the Installer guide).
Safety instructions
WARNINGS AND CAUTIONS
A Warning indicates a condition, hazard or unsafe practice that can result in
serious personal injury or death. A Caution indicates a condition, hazard or
unsafe practice that can result in minor personal injury or damage to the
product.
WARNING — This product shall only be installed, repaired or serviced
by an authorised electrician. All applicable local, regional and national
regulations for electrical installations must be respected.
— Danger to life due to high electrical voltage. Never make any changes to
components, software or connected cables.
— The installation must not be carried out in the vicinity of explosive
atmospheres or in areas where there is a risk of flowing water.
— The terminals in the backplate are energised when the power circuit is
closed and must never be in direct contact or in contact with anything other
than the plug-in electronics (Chargeberry).
— Never use or touch the product if it is damaged or does not function
properly.
— In case of a critical error, the charger will alert the user with a warning
sound and flashing red light on the light strip. Turn off the power and remove
the charging cable from the Charging Robot. The power can then be turned back
on if necessary. The flashing red light will continue, but the warning sound
will stop when the charging cable is disconnected. The charger is blocked from
further use, cannot be reset and has to be replaced. Contact customer support.
CAUTION
— If a fire occurs, use CO2 for extinguishing. To extinguish it with water or
foam, the system must be first de-energized (electrically disconnected).
— Never clean the Charging Robot with high pressure or running water.
— Do not immerse the product in water or other liquids.
— Never touch the contacts of the Type 2 socket and never insert foreign
objects into the product.
— Never use the charging cable if it is damaged or if the connections are wet
or dirty.
— Do not use extension cords or adapters in combination with the product.
— Avoid direct sunlight for optimal operation in all weather conditions.
— Do not use the product near strong electromagnetic fields or in the direct
vicinity of radio transmitters.
— The product must be installed on a permanent location. The connections of
the Chargeberry and backplate are designed for a limited number of plugging
cycles.
— Make sure that children do not play with the product.
— Make sure the charging cable does not cause a tripping hazard or risk being
run over by a car.
— The charging cable must only be removed from the Charging Robot by pulling
the plug handle, not by pulling the cable.
Additional important information
Simplified Declaration of Conformity
Hereby, Easee AS declares that Easee Home/Charge defined in this manual is in
compliance with the EU Radio Equipment Directive 2014/53/EU, including
electrical safety requirements and electromagnetic compatibility as required
by article 3.1 (a) and (b).
Hereby, Easee AS declares that Easee One and Easee Charge defined in this
manual and sold in the UK after January 2023 is in compliance with the UK
Radio Equipment Regulations 2017, including electrical safety requirements and
electromagnetic compatibility as required by article 6.1 (a) and (b).
The full text of the EU Declaration of Conformity is available at:
easee.com/support/DoC
The full text of the UK Declaration of Conformity and the UK Smart Charging
Regulations Statement of Compliance and Technical File are available at the
following internet address: easee.com/manuals
Transportation
The charger should always be transported within its original packaging. No
other items should be stored on top of the box other than Easee chargers.
Should the box be dropped or otherwise impacted, a visual inspection should be
done in order to verify potential damage.
Storage
The electronics are hermetically sealed and will not get damaged if stored in
humid areas. However, in order to preserve the packaging and its contents, we
recommend storage in a tempered, dry and well-ventilated area. Relative
humidity should not exceed 80% and no corrosive gas should be present. Storage
or transportation environment must never exceed the limits provided in the
Technical specifications.
Dismounting
Perform a factory reset of the device before powering it down. This is done
via the Installer App. Dismounting of the backplate shall only be performed by
an authorised electrician. The power supply to the charger must be isolated
before dismounting starts. Use the installation guide and follow the steps in
reverse in order to dismount the Charging Robot in the correct order.
Data protection
When the product connects to the Internet, personal data is sent to Easee
AS. You will receive more information about data protection during the
configuration of your Charging Robot.
Waste handle
A crossed-out dustbin (WEEE symbol) indicates that a product and its
accessories must not be disposed of in household waste at the end of their
lifecycle. For the return of old devices, free collection and acceptance
points may be available in your vicinity. Observe local regulations for
correct and environmentally friendly disposal. If the old electronic equipment
contains personal data, you are responsible for deleting it yourself before
returning it.
Warranty
The device is free from material defects and is in accordance with laws and
regulations for consumer protection in the country where the product is
purchased. All correctly installed Easee hardware is covered by our 3 years
limited warranty. If your charger needs to be repaired within this warranty
period, please contact your Easee supplier. Further information can be found
at easee.support. Some countries may have extended warranty.
Returns and complaints
Contact your distributor or Easee Customer Support regarding the return and
complaint of your product.
Customer support
Download the latest manuals, find answers to frequently asked questions and
useful documents and videos for your product at easee.support.
Max transmitted power
| Radio | 100 mW at 863–870 MHz |
|---|---|
| WiFi | 50 mW at 2.4–2.472 GHz |
| GSM | 2 W at 880–915 MHz, 1 W at 1710–1785 MHz, 200 mW at 703–748 MHz, 832–862 |
MHz, 880– 915 MHz, 1710–1785 MHz and 1920–1980 MHz
The information in this document is for information purposes only, is provided
as is, and may be subject to change without notice. Easee AS including its
subsidiaries does not accept any liability for the correctness or completeness
of the information and illustrations, and is not liable or responsible for
your considerations, assessments, decisions or absence of such, or other use
of the information in this document.
No part of this publication may be re-published, reproduced, transmitted or
re-used in any other form, by any means or in any form, for your own or any
third-party’s use, unless otherwise agreed with Easee or its subsidiaries in
writing. Any permitted use shall always be done in accordance with good
practice and ensure that no harm may be caused to Easee or by misleading the
consumer.
Easee and Easee products, product names, trademarks and slogans, whether
registered or not, are Easee’s intellectual property and may not be used
without Easee’s prior written permission. All other products and services
mentioned may be trademarks or service marks of their respective owners.
February 2023 Version 1.01 © 2023 by Easee AS. All rights reserved.
Easee AS Grenseveien 19 4313 Sandnes, Norway
www.easee.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>