TESLA 3/Y Key Fob User Manual

: June 9, 2024
: Tesla

Table of Contents

3/Y Key Fob
Passive Locking and Unlocking
Replacing the Key Fob Battery
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

3/Y Key Fob
User Manual

3/Y Key Fob

Radio equipment on a similar frequency can affect the key. If this happens, move the key at least one foot (30 cm) away from other electronic devices (phones, laptops, etc.).
In the event that the key fob’s battery is dead, you can still use it to drive the vehicle by scanning the key fob on the card reader located on the driver’s side door pillar (like the key card).
Instructions for changing the battery are provided in Replacing the Key Fob Battery on page 12.
NOTE: You can use the same key fob with multiple Model Y vehicles provided you authenticate it (see Managing Keys on page 13). However, key fob works with only one Model Y at a time. Therefore, to use a key fob for a different Model Y, touch its flat side against the card reader on the driver’s side door pillar.
NOTE: Model Y supports up to four different key fobs.
CAUTION: Protect the key from impact, high temperatures, and damage from liquids. Avoid contact with solvents, waxes, and abrasive

Passive Locking and Unlocking

Locking and unlocking Model Y with your key fob is conveniently hands-free. Although you must be carrying a paired key fob, there is no need to use it. Model Y has sensors around the vehicle that can recognize the presence of a key fob within a range of approximately six feet (two meters). Therefore, you can keep your key fob in your pocket or purse and simply pull on the door handle to unlock. When carrying your key fob with you, you can also open the trunk without having to use the key by pressing the lift gate’s exterior door handle. If Walk-Away Door Lock is enabled, Model Y automatically locks when you exit and the key fob is no longer in range (see Walk-Away Door Lock on page 15). Passive locking and unlocking is automatically enabled when you pair your key fob to Model Y.
Although you can use the same key fob with multiple vehicles, it can only be paired to one vehicle at a time. To activate a paired key fob to a different vehicle, touch the flat side onto the driver’s side door pillar and click any button on the key fob to confirm.
NOTE: For increased security, passive locking and unlocking disables after being stationary for five minutes while within vehicle range when the vehicle is not in use (for example, you are standing outside your vehicle). In this situation, you must shake or press a button on the key fob to re-enable passive locking and unlocking.

Replacing the Key Fob Battery

Under normal use, the accessory key fob has a battery that lasts for up to one year, depending on key fob version and selected vehicle settings. When the battery is low, a message displays on the touchscreen.

To replace the key fob battery:

With the key fob placed button side down on a soft surface, release the bottom cover, using a small flat bladed tool.
Remove the battery by lifting it away from the retaining clips.
While avoiding touching the battery’s flat surfaces, insert the new battery (type CR2032 ) with the ‘+’ side facing up.
NOTE: Wipe the battery clean before fitting and avoid touching the battery’s flat surfaces. Finger marks on the flat surfaces of the battery can reduce battery life.
NOTE: CR2032 batteries can be purchased from any retailer that sells batteries.
Holding the bottom cover at an angle, align the tabs on the cover with the corresponding slots on the key fob, then press the cover firmly onto the key fob until it snaps into place.