POTTER VSRCTSK Cover Tamper Kit Series Vane Type Waterflow Alarm Switch Owner’s Manual
- June 9, 2024
- POTTER
Table of Contents
POTTER VSRCTSK Cover Tamper Kit Series Vane Type Waterflow Alarm Switch
The VSRCTSK Cover Tamper Switch Kit provides a SPDT (single pole, double throw) contact that is used to detect the removal of the cover from the VSR Series Vane Type Waterflow Switch, and can be field installed.
CAUTION
Carefully read and follow the instructions provided. Failure to read and follow the instructions provided could result in improper operation.
WARNING
- Installation must be performed by qualified personnel and in accordance with all national and local codes and ordinances.
- Shock hazard. Disconnect power source before servicing. Serious injury or death could result.
- Risk of explosion. Not for use in hazardous locations. Serious injury or death could result.
INSTALLATION
-
The VSRCTSK must be installed on the switch housing cover on the same side of the conduit entrance being used.
-
Insert the leads from the switch into the strain relief slot located in the switch housing as shown in Fig. 1.
-
Mount the tamper switch in the notches provided in the switch housing cover using the screws, washers, and nuts provided, as shown in
Figure 2. For proper operation the mounting screws must be bottomed in the notches on the cover. -
Pull up on the wires to lock them in the strain relief notches in the switch housing.
WIRING INFORMATION, CIRCUIT CONDITION WITH COVER AFFIXED
N.O. – For normally open circuit with cover attached use Common (white)
and Normally Open (black) Leads.
N.C. – For normally closed circuit with cover attached use Common (white)
and Normally Closed (red) Leads.
Adjustment – Some adjustment may be necessary to correctly position the
blade of the switch. This can be accomplished by carefully bending the blade
of the switch upward toward the cover to ensure engagement. Be careful to bend
the switch-blade at the center to avoid damage to the switch.
UL Listed, FM Approved
SWITCH CONTACTS: SPDT (Form C)
CONTACT RATING:
3 Amps at 250VAC
5 Amps at 125VAC
1 mA at 5 VDC min
TERMINATIONS: 8″ (20 cm) N.O. 22 AWG wire leads
STOCK NO: 0090148
Customer Support
Potter Electric Signal Company, LLC • St. Louis, MO • Customer Service: 866-572-3005/Tech Phone: 866-956-0988/Canada 888-882-1833 • www.pottersignal.com
References
- Fire Alarm Resources | Download fire alarm documents
- Potter Electric: Fire Alarms & Fire Sprinkler Systems
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>