CombiSteel 7075.0120 Horizontal Outlet Floor Drain Installation Guide
- June 9, 2024
- CombiSteel
Table of Contents
CombiSteel 7075.0120 Horizontal Outlet Floor Drain Installation Guide
PLEASE CHECK AND MAKE SURE THAT THE BELOW LISTED PARTS ARE SUPPLIED
* THE DISTANCE BETWEEN THE TOP OF THE EXISTING CONCRETE AND THE ANTICIPATED FINISH ED FLOOR LEVEL SHOULD BE EQUAL TO THE TOTAL HEIGHT OF THE FLOOR DRAIN. IN CASE THIS DISTANCE IS MORE, FOUR PIECES OF MS BOLTS AND EIGHT PIECES OF MS NUTS SHOULD BE OBTAINED AND USED AS ADJUSTING FEET. THE LENGTH OF THE BOLTS WILL BE SPECIFIED ACCORDING TO THE AFOREMENTIONED DISTANCE.
* IN CASE APPLICATION OF ADJUSTING FEET IS REQUIRED, AS A FIRST STEP,THE
BOLTS AND NUTS ARE FIXED ON THE
BODY AS SHOWN BELOW.
- THE FLOOR DRAIN IS PLACED AT THE ALREADY SPECIFIED LOCATION.
- THE HEIGHT OF THE FLOOR DRAIN IS ADJUSTED. THE TOP OF THE FLOOR DRAIN SHOULD BE ADJUSTED 0.5-1.00 MM BELOW THE ANTICIPATED FINISH ED FLOOR LEVEL.
* THE FLOOR DRAIN IS CONNECTED TO THE PVC PIPE. PLEASE MAKE SURE TO HAVE THE REQUIRED SLOPE AND THE ANGLE OF FLOW.
- APPROXIMATEL V 30-40 MM OF CONCRETE IS POURED AT THE BOTTOM OF EACH FOOT AND LEFT TO CURE. MAKE SURE THAT THE FLOOR DRAIN IS KEPT UNTOUCHED TILL THE CONCRETE IS PROPERLY CURED.
- THE WHOLE GAP AROUND AND UNDER THE FLOOR DRAIN SHOULD BE FILLED WITH CONCRETE GRADUALLY AND HAVE A SMOOTH TOP SURFACE.
- AS THE LAST STEP, TILING IS APPLIED •
- THE WHOLE SURFACE OF THE FLOOR DRAIN MUST BE CLEANED PROPERLY BEFORE PLACING THE FILTER ELEMENT AND THE GRATE.
- PLEASE MAKE SURE THAT THE RUBBER PLUG IS ALWAYS ON. THE RUBBER PLUG MAY BE TAKEN OFF FOR MAINTENANCE ONLY.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>