George Kovacs P1368-619 Nexpo Linear Pendant Light Instruction Manual
- June 9, 2024
- GEORGE KOVACS
Table of Contents
P1368-619 Nexpo Linear Pendant Light
Instruction Manual
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE
(Fig. 1)
Set# A-021-195112
- Mounting Plate
- Ground Screw
- Mounting Screw*2
Spanner#WRH-Y-89
Rod# W30-1-842(F1)
W30-1-844(F2)
W30-H-84*2(F3)
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Shut off power at the circuit breaker and remove the old fixture including the mounting hardware.
-
Determine the desired hanging height and thread rods (F1, F2 and F3) to nipple (J) of the fixture body. Carefully pass the wires through each rod during assembly. Secure swivels (G) onto rods (F1).
-
Align canopy (H), metal support plate (I) followed by lock washer (F) and metal washer (E) onto swivels (G) and secure with hex nuts (D) via wrench (P) included.
-
Position the mounting plate (A) on the ceiling and mark the location of the two drywall anchors (K). Pre-drill the holes for the drywall anchors (K). Then insert the drywall anchors (K) into the ceiling.
-
Attach mounting plate (A) to the outlet box using mounting screws (B) (Size: #8-32N*L0.5”) and wood screws (O) into drywall anchors (K). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2) -
At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION
(Fig. 1)
- Align canopy (H) onto mounting plate (A) and secure with screws (C).
- Place the glass shade (M) over the socket (L) and secure with the screw shell (N).
- Install the light bulb (Q) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
- The dendrites of this lamp have the function of rotating a certain angle so that customers can make their own adjustments.
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
LA-2884E
Documents / Resources
|
George Kovacs P1368-619 Nexpo Linear Pendant
Light
[pdf] Instruction Manual
P1368-619 Nexpo Linear Pendant Light, P1368-619, Nexpo Linear Pendant Light,
Linear Pendant Light, Pendant Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>