Warehouse of Tiffany PD037-3 Dalen 16 Inch 3 Light Indoor Rustic Black and Faux Wood Grain Chandelier Instructions
- June 12, 2024
- Warehouse of Tiffany
Table of Contents
PD037-3 Dalen 16 Inch
3 Light Indoor Rustic Black and Faux Wood Grain
Chandelier Instructions
Product installation instructions
Please read this manual before installation. Please keep it for reference
WIRE CONNECTION DIAGRAM
Wires meet safety standards are recommended to connect the
supply circuit
CAUTION:
Risk of fire
CANPY INSTALLATION INSTRUCTIONS
Please read all instructions carefully before you proceed to install make sure
that the power supply is turned off and remains off until installation is
complete please not that cach part has been assigned a letter please proceed
in an alphabetical order.
A. Existing Electrical box
B. junction caps
C. crossbar
D. Crossbar screws
E. Wire
attach the crossbar(B)to the existing electrical box(A) using the two crossbar
screws(D)which are not supplied and should already in your box pass the main
wire(E)and ground wire through the crossbar(C)until the end of the main
wire(E)reaches the electrical
box(A) where you can wire use electrician connections, Be sure when connecting
the wire use elcetrician approved junction caps(B),stow the excess wire in the
electrical box(A).raise the canopy. attach canopy to ceiling. and hold the
canopy.
RELATED TO INSTALLATION
- 1b ensure the success of the installation.be sure to read these instructions carefully before beginning.
- Before installations. prepare the required tools. such as Blade screwdriver, Adjustable wrench, step ladder, wire cutter.
- Al T electrical connections must be in accordance with the National Electrical Code. Qualified licensed electricians are re- quired to conduct the installation of electrical wiring.
- The outlet box that is connected to the lighting must be directly supported by the building structure.
- Before starting the installation. Disconnect the power to prevent electrical shock.
NOTE: The important safeguards and installations appearing in this manual are not meant to cover all possible conditions and situations that may occur. if must be understood that common sense, caution and care are factors which can’1 be built into any product. Th cre factors must be applicd by the person(S) caring for and operating the fixture.
CAUTION
- Rated 110-130V/6011z bulb 40W-60W maximum.
- Care should be taken to avoid damage to the surface of lighting and wire, wearing gloves are recommended when installing.
- Keep lighting away from acid, alkali and other corrosive chemical or gas, clean the lighting with clean soft cloth only.
- Installation must be carried out by qualified clectrician only.
- Disconnect the power before installing, cleaning and replacing lighting.
- Never cover the lighting when power is connected.
INSTRUCTIONS
- Take out all lamp parts. The picture below shows the exact items that you receive in this product. Please note that this picture may look different from the computer generate part table. The parts in the part table are not assembled but some parts in this part picture are assembled, so there may be fewer items in the picture than in the table.
- Part Table Please note: ‘The parts in this table are completely unassembled for illustrative purpose. In the actual product that you receive, some parts are assembled and attached together.
Using the following tools :
| | | |
---|---|---|---|---
gloves| wrench| The screwdriver| Test pancil| Tapping screw
