George Kovacs 9451 Larry Pendant Light Instruction Manual
- June 9, 2024
- GEORGE KOVACS
Table of Contents
INSTALLATION INSTRUCTIONS
For Model # 9451(Rev. 10/24/2018)
READ AND SAVE THESE INSTRUCTIONS
9451 Larry Pendant Light
WARNING ! SHUT POWER OFF ATFUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Shut off power at the circuit breaker and remove old fixture including the crossbar.
-
Attach the Crossbar(C) to the Outlet box in the ceiling with two screws (D). The side of the Crossbar with “GND” marked on it and two convex points must face out.
-
Determine desired distance from ceiling to hang the fixture, and if necessary, cut cord to length plus five inches. Run the Wire Cord (A) through the Cap Nut (G), Canopy (F) and Nipple (E) then feet several inches of the cord end through the middle hole in the Crossbar(C).
-
Install the Strain Relief Bushing (B) by unscrewing the Screw (E) and pushing the cord through the center of both parts until about 5” of cord is exposed. Tighten the screw. (You may need someone to hold the fixture while installing he Strain Relief Bushing.) The fixture can now hang from the Bushing (B) against the Crossbar(C) with a screw.
-
Carefully cut and remove approximately 4” of the outer sheathing from cord end and strip 1/2” of the wire ends bare to expose the copper strands.
CONNECTING THE WIRES (Fig. 2)
-
At this point, connect the electrical wire as shown in figure 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures Ground Wire to it. Otherwise, connect the fixture Ground Wire directly to the crossbar using the Green Screw provided.
-
Slip the Nipple (E) to the Crossbar(C) and thread part way into the hole.
-
Slip the Canopy (F) and Cap Nut (G) up to the ceiling and lock the Canopy (F) in place by threading the Cap Nut onto the Nipple.
-
For installing bulb or replacing bulb at a later date, unscrew the two Screws (H) and remove the bottom Sleeve (I). After installation, replace the Bottom Sleeve (I) and secure with the Screws (H). Install the light bulb (not included) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box and test
the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO
ENSURE PROPER WIRING AND INSTALLATION.
LA-531E
Documents / Resources
|
George Kovacs 9451 Larry Pendant
Light
[pdf] Instruction Manual
9451 Larry Pendant Light, 9451, Larry Pendant Light, Pendant Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>