George Kovacs P1205 Pitch Outdoor LED Wall Light Instruction Manual
- October 29, 2023
- GEORGE KOVACS
Table of Contents
INSTALLATION INSTRUCTIONS
Item# P1205
READ AND SAVE THESE INSTRUCTIONS
P1205 Pitch Outdoor LED Wall Light
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware. -
Carefully remove the fixture from the carton and check that all parts are included as show in Figure 1.
-
Loosen screws (D), and separate mounting plat (A) from back plate (C).
-
Attach the mounting plat (A) to the junction box with junction box screws (B) (size: 8-32*1/2”L). The side of the mounting plate marked “GND” must be face out.
CONNECTION THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig.2, making sure that all wire nuts are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground Wire to it. Otherwise, connect the fixture’s ground wire directly to the circular strap using the green screw provided. Tuck the wire connections neatly into the junction box.
FINISHING THE INSTALLATION (Fig. 1)
-
Align back plate (C) onto mounting plate (A), and secure with screws (D).
-
To prevent moisture from entering the outlet box and causing a short circuit, use clear caulking (i.e. Indoor/Outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall leaving a space at bottom to allow moisture a means to escape (Fig.3).
Your installation is now complete. Return power to the junction box and test
the fixture.
CAUTION /ATTENTION: When handling the fixture, do not apply pressure to
the LED. Hold the fixture by the base or back plate (C) only.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type dimmers